DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

LTC1597AIN(RevA) 查看數據表(PDF) - Linear Technology

零件编号
产品描述 (功能)
生产厂家
LTC1597AIN Datasheet PDF : 20 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
LTC1591/LTC1597
ELECTRICAL CHARACTERISTICS The denotes specifications that apply over the full operating temperature
range. VCC = 5V ±10%, VREF = 10V, IOUT1 = AGND = DGND = 0V, TA = TMIN to TMAX, unless otherwise noted.
SYMBOL PARAMETER
Analog Outputs (Note 4)
COUT
Output Capacitance (Note 4)
Digital Inputs
VIH
Digital Input High Voltage
VIL
Digital Input Low Voltage
IIN
Digital Input Current
CIN
Digital Input Capacitance
Timing Characteristics
tDS
Data to WR Setup Time
tDH
Data to WR Hold Time
tWR
WR Pulse Width
tLD
LD Pulse Width
tCLR
Clear Pulse Width
tLWD
WR to LD Delay Time
Power Supply
VDD
Supply Voltage
IDD
Supply Current
CONDITIONS
DAC Register Loaded to All 1s: COUT1
DAC Register Loaded to All 0s: COUT1
(Note 4) VIN = 0V
Digital Inputs = 0V or VCC
MIN
2.4
60
0
60
110
60
0
4.5
TYP MAX
115
130
70
80
0.8
0.001
±1
8
5
5.5
10
UNITS
pF
pF
V
V
μA
pF
ns
ns
ns
ns
ns
ns
V
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: ±1LSB = ±0.006% of full scale = ±61ppm of full scale for the
LTC1591/LTC1591-1. ±1LSB = ±0.0015% of full scale = ±15.3ppm of full
scale for the LTC1597/LTC1597-1.
Note 3: Using internal feedback resistor.
Note 4: Guaranteed by design, not subject to test.
Note 5: I(OUT1) with DAC register loaded to all 0s.
Note 6: Typical temperature coefficient is 100ppm/°C.
Note 7: IOUT1 load = 100Ω in parallel with 13pF.
Note 8: To 0.006% for a full-scale change, measured from the rising edge
of LD for the LTC1591/LTC1591-1. To 0.0015% for a full-scale change,
measured from the rising edge of LD for the LTC1597/LTC1597-1.
Note 9: VREF = 0V. DAC register contents changed from all 0s to all 1s or
all 1s to all 0s.
Note 10: VREF = 6VRMS at 1kHz. DAC register loaded with all 1s.
Note 11: Calculation from en = 4kTRB where: k = Boltzmann constant
(J/°K), R = resistance (Ω), T = temperature (°K), B = bandwidth (Hz).
Note 12: Midscale transition code: 01 1111 1111 1111 to 10 0000 0000
0000 for the LTC1591/LTC1591-1 and 0111 1111 1111 1111 to 1000
0000 0000 0000 for the LTC1597/LTC1597-1.
Note 13: R1 and R2 are measured between R1 and RCOM, REF and RCOM.
Note 14: Measured using the LT1468 op amp in unipolar mode for I/V
converter and LT1468 I/V and LT1001 reference inverter in bipolar mode.
Sample Rate = 50kHz, Signal Frequency = 1kHz, VREF = 5V, TA = 25°C.
15917fa
4

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]