AD7890SQ-2 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

AD7890SQ-2

LC2MOS 8-Channel, 12-Bit Serial Data Acquisition System

Analog Devices 

In the self-clocking mode, the AD7890 indicates when

conversion is complete by bringing the RFS line low and

initiating a serial data transfer. In the external clocking mode,

there is no indication of when conversion is complete. In many

applications, this is not a problem as the data can be read from

the part during conversion or after conversion. However,

applications that seek to achieve optimum performance from

the AD7890 has to ensure that the data read does not occur

during conversion or during 500 ns prior to the rising edge

of CONVST.

This can be achieved in either of two ways. The first is to ensure

in software that the read operation is not initiated until 5.9 μs

after the rising edge of CONVST. This is only possible if the

software knows when the CONVST command is issued. The

second scheme would be to use the CONVST signal as both the

conversion start signal and an interrupt signal. The simplest

way to do this is to generate a square wave signal for CONVST

with high and low times of 5.9 μs (see Figure 8). Conversion is

initiated on the rising edge of CONVST. The falling edge of

AD7890

CONVST occurs 5.9 μs later and can be used as either an active

low or falling edge-triggered interrupt signal to tell the

processor to read the data from the AD7890. Provided the read

operation is completed 500 ns before the rising edge of

CONVST, the AD7890 operates to specification.

This scheme limits the throughput rate to 11.8 μs minimum.

However, depending upon the response time of the

microprocessor to the interrupt signal and the time taken by the

processor to read the data, this may be the fastest which the

system could have operated. In any case, the CONVST signal

does not have to have a 50:50 duty cycle. This can be tailored to

optimize the throughput rate of the part for a given system.

Alternatively, the CONVST signal can be used as a normal

narrow pulse width. The rising edge of CONVST can be used as

an active high or rising edge-triggered interrupt. A software

delay of 5.9 μs can then be implemented before data is read

from the part.

CONVST

SCLK

RFS

TFS

tCONVERT

500ns MIN

CONVERSION IS

INITIATED AND

TRACK/HOLD GOES

INTO HOLD

CONVERSION MICROPROCESSOR

ENDS 5.9µs

INT SERVICE

LATER

OR POLLING

ROUTINE

SERIAL READ

AND WRITE

OPERATIONS

READ AND WRITE

OPERATIONS SHOULD

END 500ns PRIOR

TO NEXT RISING

EDGE OF CONVST

Figure 8. CONVST Used as Status Signal in External Clocking Mode

NEXT CONVST

RISING EDGE

Rev. C | Page 15 of 28

Share Link: