25Q16BV 查看數據表（PDF） - Winbond

零件编号

产品描述 (功能)

生产厂家

25Q16BV

16M-Bit Serial Flash Memory With Dual And Quad SPI

Winbond 

W25Q16BV

11.2.5 Write Enable (06h)

The Write Enable instruction (Figure 4) sets the Write Enable Latch (WEL) bit in the Status Register to a

1. The WEL bit must be set prior to every Page Program, Sector Erase, Block Erase, Chip Erase and

Write Status Register instruction. The Write Enable instruction is entered by driving /CS low, shifting the

instruction code “06h” into the Data Input (DI) pin on the rising edge of CLK, and then driving /CS high.

Figure 4. Write Enable Instruction Sequence Diagram

11.2.6 Write Disable (04h)

The Write Disable instruction (Figure 5) resets the Write Enable Latch (WEL) bit in the Status Register to

a 0. The Write Disable instruction is entered by driving /CS low, shifting the instruction code “04h” into the

DI pin and then driving /CS high. Note that the WEL bit is automatically reset after Power-up and upon

completion of the Write Status Register, Page Program, Sector Erase, Block Erase and Chip Erase

instructions.

Figure 5. Write Disable Instruction Sequence Diagram

- 21 -

Publication Release Date: July 08, 2010

Revision F

Share Link: