SAF-C167CR-16RM 查看數據表（PDF） - Siemens AG
零件编号
产品描述 (功能)
生产厂家
SAF-C167CR-16RM Datasheet PDF : 67 Pages
| |||
20Dec96@09:25h Intermediate Version
C167CR-16RM
Parameter
Port 6 active current 4)
PORT0 configuration current 4)
XTAL1 input current
Pin capacitance 5)
(digital inputs/outputs)
Power supply current
Idle mode supply current
Power-down mode supply current
Symbol
Limit Values
min.
IP6L 3)
IP0H 2)
IP0L 3)
-500
–
-100
IIL CC –
CIO CC –
max.
–
-10
–
±20
10
ICC
–
IID
–
IPD
–
20 +
5 * fCPU
20 +
2 * fCPU
100
Unit Test Condition
µA
V V = OUT
OL1max
µA
VIN = VIHmin
µA
VIN = VILmax
µA 0 V < VIN < VCC
pF f = 1 MHz
TA = 25 °C
mA RSTIN = VIL2
fCPU in [MHz] 6)
mA RSTIN = VIH1
fCPU in [MHz] 6)
µA VCC = 5.5 V 7)
Notes
1) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
2) The maximum current may be drawn while the respective signal line remains inactive.
3) The minimum current must be drawn in order to drive the respective signal line active.
4) This specification is only valid during Reset, or during Hold- or Adapt-mode. Port 6 pins are only affected, if
they are used for CS output and the open drain function is not enabled.
5) Not 100% tested, guaranteed by design characterization.
6) The supply current is a function of the operating frequency. This dependency is illustrated in the figure below.
These parameters are tested at VCCmax and 20 MHz CPU clock with all outputs disconnected and all inputs
at VIL or VIH.
7) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to
0.1 V or at VCC – 0.1 V to VCC, VREF = 0 V, all outputs (including pins configured as outputs) disconnected.
8) Overload conditions occur if the standard operatings conditions are exceeded, ie. the voltage on any pin
exceeds the specified range (ie. VOV > VCC+0.5V or VOV < VSS-0.5V). The absolute sum of input overload
currents on all port pins may not exceed 50 mA. The supply voltage must remain within the specified limits.
39
Semiconductor Group
Share Link: 