Philips Semiconductors
TEA1532
GreenChip™II SMPS control IC
Table 5: Characteristics …continued
Tamb = 25 °C; VCC = 15 V; all voltages are measured with respect to ground (pin 2); currents are positive when flowing into
the IC; unless otherwise specified.
Symbol
Parameter
Conditions
Min Typ Max Unit
Oscillator
fosc
oscillator frequency (fixed
VCTRL < 1 V
frequency)
50 63 75 kHz
Duty cycle control (pin CTRL)
Vmin
minimum voltage for maximum
duty cycle
-
1.0 -
V
Vmax
maximum voltage for minimum
duty cycle
-
1.5 -
V
∆Islopecomp/∆t
slope compensation current
VCTRL(detect)
Control detect level
Protection and timing input (pin PROTECT)
−1.2 −1 −0.8 µA/µs
0.56 0.63 0.70 V
Vtrip
Vtrip(latch)
VCC(latch)(reset)
trip level
trip level for latch
voltage level on pin VCC which
resets the latch
VCC(latch) < 2.3 V
2.37 2.5
2.85 3
-
4.5
2.63 V
3.15 V
-
V
Icharge
charge current
Idischarge
discharge current
Valley switch (pin DRAIN)
VCTRL < 0.63 V
−57 −50 −43 µA
-
100 -
nA
∆V/∆tvalley
valley recognition voltage
change
−43 -
+43 V/µs
tvalley-swon
delay from valley recognition to
switch-on
[1] -
150 -
ns
Overcurrent and winding short-circuit protection (pin SENSE)
Vsense(max)
maximum source voltage for
OCP
∆V/∆t = 0.1 V/µs
0.48 0.52 0.56 V
tPD
propagation delay from
∆V/∆t = 0.5 V/µs
detecting Vsense(max) to
switch-off
-
140 185 ns
tleb
blanking time for current and
winding short-circuit protection
330 400 470 ns
Iss
soft start current
Brown-out protection (pin DEM)
Vsense < 0.5 V
45 60 75 µA
Ibrown-out
brown-out protection current
A constant I(brown-out) is drawn
from pin DEM.
[2] −68 −60 −52 µA
ton(min)(brown-out)
minimum on-time for enabling
the brown-out protection.
1.5 2
2.5 µs
Driver (pin DRIVER)
Isource
Isink
Vo(max)
source current
sink current
maximum output voltage
VCC = 9.5 V; VDRIVER = 2 V
VCC = 9.5 V;
VDRIVER = 2 V
VDRIVER = 9.5 V
VCC > 12 V
-
−170 −88 mA
-
300 -
mA
400 700 -
mA
-
11.5 12 V
9397 750 13113
Preliminary data sheet
Rev. 01 — 28 May 2004
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
14 of 27