Compact, Low-Cost 1S/2S Fuel Gauges
Revision History
REVISION REVISION
NUMBER DATE
DESCRIPTION
0
7/08 Initial release
• Corrected the order of the pins in the Pin Configuration
• Changed the max operating voltage from 5.5V to 4.5V
1
10/08
• Inserted the “CELL Pin Input Impedance” specification into the DC Electrical
Characteristics table
• Corrected the order of the pins in the Pin Description table and changed the max
operating voltage for the VDD pin
• Added the following sentence to the Registers section: “Register reads and writes
are only valid if all 16 bits are transferred”
2
3/09
• Added the following sentence to the Write Data Protocol section: “A valid write
must include both register bytes”
• Added the following sentence to the Read Data Protocol section: “Both register
bytes must be read in the same transaction for the register data to be valid”
3
4/10
Exposed pad connection to ground in Figures 5 and 6; corrected errors in
specifications
PAGES
CHANGED
—
1, 2, 3, 5, 8
6, 11
1, 2, 7, 9, 13
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 13
© 2010 Maxim Integrated Products
Maxim is a registered trademark of Maxim Integrated Products, Inc.