DSP56F807 查看數據表（PDF） - Freescale Semiconductor
零件编号
产品描述 (功能)
生产厂家
DSP56F807 Datasheet PDF : 60 Pages
| |||
Serial Communications Interface (SCI) Signals
2.10 Serial Communications Interface (SCI) Signals
Table 2-14 Serial Peripheral Interface (SPI) Signals
No. of
Pins
1
Signal
Name
MISO
Signal
Type
Input/
Output
State During
Reset
Input
Signal Description
SPI Master In/Slave Out (MISO)—This serial data pin is an input to a
master device and an output from a slave device. The MISO line of a
slave device is placed in the high-impedance state if the slave device is
not selected.
GPIOE6 Input/Outp
ut
Input
Port E GPIO—This pin is a General Purpose I/O (GPIO) pin that can
individually be programmed as input or output pin.
1
MOSI
Input/
Output
Input
After reset, the default state is MISO.
SPI Master Out/Slave In (MOSI)—This serial data pin is an output from
a master device and an input to a slave device. The master device
places data on the MOSI line a half-cycle before the clock edge that the
slave device uses to latch the data.
GPIOE5 Input/Outp
ut
Input
Port E GPIO—This pin is a General Purpose I/O (GPIO) pin that can
individually be programmed as input or output pin.
After reset, the default state is MOSI.
1
SCLK Input/Outp
Input
SPI Serial Clock—In master mode, this pin serves as an output,
ut
clocking slaved listeners. In slave mode, this pin serves as the data
clock input.
GPIOE4 Input/Outp
ut
Input
Port E GPIO—This pin is a General Purpose I/O (GPIO) pin that can
individually be programmed as input or output pin.
1
SS
Input
Input
After reset, the default state is SCLK.
SPI Slave Select—In master mode, this pin is used to arbitrate multiple
masters. In slave mode, this pin is used to select the slave.
GPIOE7 Input/Outp
ut
Input
Port E GPIO—This pin is a General Purpose I/O (GPIO) pin that can
individually be programmed as input or output pin.
After reset, the default state is SS.
56F807 Technical Data Technical Data, Rev. 16
Freescale Semiconductor
17
Share Link: 