ACPL-M75L-060E 查看數據表（PDF） - Avago Technologies

零件编号

产品描述 (功能)

生产厂家

ACPL-M75L-060E

Single-channel High Speed 15 MBd CMOS optocoupler with Glitch-Free Power-Up Feature

Avago Technologies 

Insulation and Safety Related Specifications

Parameter

Symbol

Minimum External Air

Gap (Clearance)

L(I01)

Minimum External

Tracking (Creepage)

L(I02)

Minimum Internal Plastic

Gap (Internal Clearance)

Tracking Resistance

CTI

(Comparative Tracking Index)

Isolation Group

Value

≥5

≥5

0.08

≥175

IIIa

Units

mm

mm

mm

Volts

Conditions

Measured from input terminals to output terminals,

shortest distance through air.

Measured from input terminals to output terminals,

shortest distance path along body.

Insulation thickness between emitter and detector;

also known as distance through insulation.

DIN IEC 112/VDE 0303 Part 1

Material Group (DIN VDE 0110, 1/89, Table 1)

All Avago Technologies data sheets report the creepage

and clearance inherent to the optocoupler component it-

self. These dimensions are needed as a starting point for

the equipment designer when determining the circuit

insulation requirements. However, once mounted on a

printed circuit board, minimum creepage and clearance

requirements must be met as specified for individual

equipment standards. For creepage, the shortest distance

path along the surface of a printed circuit board between

the solder fillets of the input and output leads must be

considered. There are recommended techniques such as

grooves and ribs which may be used on a printed circuit

board to achieve desired creepage and clearances. Creep-

age and clearance distances will also change depending

on factors such as pollution degree and insulation level.

IEC/EN/DIN EN 60747-5-2 Insulation Related Characteristics (Option 060)

Description

Installation classification per DIN VDE 0110/1.89, Table 1

for rated mains voltage ≤150 V rms

for rated mains voltage ≤300 V rms

Climatic Classification

Pollution Degree (DIN VDE 0110/1.89)

Maximum Working Insulation Voltage

Input to Output Test Voltage, Method b†

VIORM x 1.875 = VPR, 100% Production

Test with tm = 1 sec, Partial Discharge < 5 pC

Input to Output Test Voltage, Method a†

VIORM x 1.5 = VPR, Type and Sample Test,

tm = 60 sec, Partial Discharge < 5 pC

Highest Allowable Overvoltage†

(Transient Overvoltage, tini = 10 sec)

Safety Limiting Values

(Maximum values allowed in the event of a failure,

also see Thermal Derating curve, Figure 11.)

Case Temperature

Input Current

Output Power

Insulation Resistance at TS, V10 = 500 V

Symbol

VIORM

VPR

VPR

VIOTM

Ts

Is, INPUT

Ps,OUTPUT

RIO

option 060

I-IV

I-III

55/105/21

2

560

1050

840

4000

150

150

600

≥109

Units

VPEAK

VPEAK

VPEAK

VPEAK

°C

mA

mW

Ω

5

Share Link: