AD5697R 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

AD5697R

Dual, 12-Bit nanoDAC+ with 2 ppm/°C Reference, I2C Interface

Analog Devices 

AD5697R

Data Sheet

READ OPERATION

When reading data back from the AD5697R DACs, the user

begins with an address byte (R/W = 0), after which the DAC

acknowledges that it is prepared to receive data by pulling SDA

low. This address byte must be followed by the control byte that

determines both the read command that is to follow and the

pointer address to read from, which is also acknowledged by the

DAC. The user configures which channel to read back and sets

the readback command to active using the control byte. Following

this, there is a repeated start condition by the master and the

address is resent with R/W = 1. This is acknowledged by the

DAC, indicating that it is prepared to transmit data. Two bytes

of data are then read from the DAC, as shown in Figure 44. A

NACK condition from the master, followed by a STOP condition,

completes the read sequence. Default readback is Channel A if

both DACs are selected.

1

9

SCL

MULTIPLE DAC READBACK SEQUENCE

The user begins with an address byte (R/W = 0), after which the

DAC acknowledges that it is prepared to receive data by pulling

SDA low. This address byte must be followed by the control byte,

which is also acknowledged by the DAC. The user configures

which channel to start the readback using the control byte.

Following this, there is a repeated start condition by the master,

and the address is resent with R/W = 1. This is acknowledged

by the DAC, indicating that it is prepared to transmit data. The

first two bytes of data are then read from DAC Input Register A

that is selected using the control byte, most significant byte first,

as shown in Figure 44. The next four bytes read back are don’t care

bytes, and the next two bytes of data are the contents of DAC

Input Register B. Data continues to be read from the DAC input

registers in this auto-incremental fashion, until a NACK followed

by a stop condition follows. If the contents of DAC Input Register B

are read out, the next bytes of data that are read are from the

contents of DAC Input Register A.

1

9

SDA

0

0

0

1

1 A1

A0 R/W

DB23 DB22 DB21 DB20 DB19 DB18 DB17 DB16

START BY

MASTER

FRAME 1

SLAVE ADDRESS

ACK. BY

AD5697R

FRAME 2

COMMAND BYTE

ACK. BY

AD5697R

1

9

1

9

SCL

SDA

0

0

REPEATED START BY

MASTER

0

1

1 A1

FRAME 3

SLAVE ADDRESS

1

SCL

(CONTINUED)

A0 R/W

DB15 DB14 DB13 DB12 DB11 DB10 DB9 DB8

ACK. BY

AD5697R

ACK. BY

MASTER

9

SDA

(CONTINUED)

DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0

FRAME 5

SLAVE ADDRESS

SIGNIFICANT DATA BYTE n

NACK. BY STOP BY

MASTER MASTER

Figure 44. I2C Read Operation

Rev. B | Page 20 of 27

Share Link: