ADM1171(Rev0) 查看數據表（PDF） - Analog Devices
零件编号
产品描述 (功能)
生产厂家
ADM1171 Datasheet PDF : 16 Pages
| |||
ADM1171
PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS
ADM1171-1AUJ
TIMER 1
8 VCC
GND 2 TOP VIEW 7 SENSE
SS 3 (Not to Scale) 6 CSOUT
ON 4
5 GATE
Figure 2. Pin Configuration, 1AUJ Model
ADM1171-2AUJ
TIMER 1
8 VCC
GND 2 TOP VIEW 7 SENSE
SS 3 (Not to Scale) 6 CSOUT
ON-CLR 4
5 GATE
Figure 3. Pin Configuration, 2AUJ Model
Table 4. Pin Function Descriptions
Pin No. Mnemonic Description
1
TIMER
Timer Input Pin. The initial and circuit breaker timing cycles are set by this external capacitor. The initial timing
delay is 272.9 ms/μF, and 21.7 ms/μF for a circuit breaker delay. When the TIMER pin is pulled beyond the upper
threshold, the GATE turns off.
2
GND
Chip Ground Pin.
3
SS
Soft Start Pin. An external capacitor between the SS pin and GND sets the ramp rate of the current limit
reference.
4
ON (ON-CLR) Input Pin. The ON (ON-CLR) pin is an input to a comparator that has a low-to-high threshold of 1.3 V with 80 mV
hysteresis and a glitch filter. The ADM1171 is reset when the ON (ON-CLR) pin is low. When the ON (ON-CLR) pin is
high, the ADM1171 is enabled. A rising edge on this pin has the added function of clearing a fault and restarting
the device on the latched off model, the ADM1171-2.
5
GATE
Gate Output Pin. An internal charge pump provides a 12 μA pull-up current to drive the gate of an N-channel
MOSFET. In an overcurrent condition, the ADM1171 controls the external FET to maintain a constant load
current.
6
CSOUT
Current Sense Output. The voltage on this pin represents the differential voltage across the VCC and SENSE pins
gained up by a factor of 20.
7
SENSE
Current Limit Sense Input Pin. The current limit is set via a sense resistor between the VCC and SENSE pin. In an
overcurrent condition, the gate of the FET is controlled to maintain the SENSE voltage at 50 mV. When this limit is
reached, the TIMER circuit breaker mode is activated. The circuit breaker limit can be disabled by connecting the
VCC pin and SENSE pin together.
8
VCC
Positive Supply Input Pin. The ADM1171 operates between 2.7 V to 16.5 V. An undervoltage lockout (UVLO)
circuit with a glitch filter resets the ADM1171 when the supply voltage drops below the specified UVLO limit.
Rev. 0 | Page 5 of 16
Share Link: 