APA2177 查看數據表（PDF） - Anpec Electronics

零件编号

产品描述 (功能)

生产厂家

APA2177

25mW Stereo Cap-Free Headphone Driver

Anpec Electronics 

APA2177

Function Description

Headphone Driver Operation

VOUT

Conventional Headphone Driver

VOUT

VDD

VDD/2

GND

VDD

GND

Shutdown Function

In order to reduce power consumption while not in use,

the APA2177 contains shutdown controllers to externally

turns off the amplifier bias circuitry. This shutdown fea-

ture turns the amplifier off when logic low is placed on the

SDN pins for the APA2177. The trigger point between a

logic high is 1.0V and logic low level is 0.35V. It is recom-

mended to switch between ground and the supply volt-

age VDD to provide maximum device performance. By

switching the SDN pins to a low level, the amplifier enters

a low-consumption current circumstance, charge pump

is disabled, and I for the APA2177 is in shutdown mode.

DD

In normal operating, the APA2177’s SDN pins should be

pulled to a high level to keep the IC out of the shutdown

mode. The SDN pins should be tied to a definite voltage

to avoid unwanted circumstance changes.

VSS

Cap-free Headphone Driver

Figure 1. Cap-free Operation

The APA2177’s headphone drivers use a charge pump

to invert the positive power supply (VDD) to negative power

supply (VSS), see figure1. The headphone drivers oper-

ate at this bipolar power supply (VDD and VSS) and the out-

puts reference refers to the ground. This feature elimi-

nates the output capacitor that is using in conventional

single-ended headphone drive amplifier. Compare with

the single power supply amplifier, the power supply range

has almost doubled.

Thermal Protection

The thermal protection circuit limits the junction tempera-

ture of the APA2177. When the junction temperature ex-

ceeds T = +150oC, a thermal sensor turns off the driver,

J

allowing the devices to cool. The thermal sensor allows

the driver to start-up after the junction temperature down

about 125oC. The thermal protection is designed with a

25oC hysteresis to lower the average TJ during continu-

ous thermal overload conditions, increasing lifetime of

the ICs.

Copyright © ANPEC Electronics Corp.

13

Rev. A.3 - Nov., 2017

www.anpec.com.tw

Share Link: