DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

APA2178 查看數據表(PDF) - Anpec Electronics

零件编号
产品描述 (功能)
生产厂家
APA2178
Anpec
Anpec Electronics Anpec
APA2178 Datasheet PDF : 30 Pages
First Prev 21 22 23 24 25 26 27 28 29 30
APA2178
Function Description
VOUT
Conventional Headphone amplifier
VOUT
VDD
VDD/2
GND
VDD
voltage PVDD to provide maximum device performance.
By switching the both RSD and LSD pins to low level, the
amplifier enters a low-consumption current circumstance,
with charge pump disabled, and very small I for the
DD
APA2178. The charge pump is enabled once either RSD
or LSD pin is pulled to high. In normal operating, the
APA2178 RSD and LSD pins should be pulled to high
level to keep the IC out of the shutdown mode. The RSD
and LSD pins should be tied to a definite voltage to avoid
unwanted mode changing.
GND
VSS
Cap-free Headphone amplifier
Figure 1. Cap-free Operation
The APA2178 is a stereo, fixed gain, and cap-free head-
phone driver. The gain is set by internal resistors, input
resistors (Ri), and feedback resistors (Rf) with -1.5V/V
(See Typical Application Circuit).
The APA2178 headphone drivers use a charge pump to
invert the positive power supply (PV ) to negative power
DD
supply (CVSS), see figure 1. The headphone drivers oper-
ate at this bipolar power supply (VDD and VSS) and the out-
puts reference refers to the ground. This feature elimi-
nates the output capacitors which are used in conven-
tional single-ended headphone amplifiers. Compared
with the single power supply amplifiers, the power sup-
ply voltage is almost double.
Shutdown Function
In order to reduce power consumption, the APA2178 con-
tains two shutdown signal input pins (LSD for left chan-
nel and RSD for right channel) to allow the respective
shutdown which turns off the bias current of the amplifier.
This shutdown feature turns the amplifier off when logic
low is placed on the RSD or LSD pin for the APA2178.
The trigger point between a logic high and a logic low
level is typically 0.6VDD and 0.3VDD. It is highly recom-
mended to switch between the ground and the supply
Copyright © ANPEC Electronics Corp.
23
Rev. A.3 - Jul., 2009
www.anpec.com.tw

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]