LB1000-SI 查看數據表（PDF） - LEM Industrial
零件编号
产品描述 (功能)
生产厂家
LB1000-SI Datasheet PDF : 3 Pages
| |||
Current Transducer LB 1000-SI/SP2
Isolation characteristics
Vd
R.m.s. voltage for AC isolation test, 50 Hz, 1 mn
6
kV
Vw Impulse withstand voltage 1.2/50 µs
17
kV
dCp Creepage distance
dCl Clearance distance
CTI Comparative Tracking Index (Group IIIa)
Min
54.5
mm
44.4
mm
225
Application examples
According to EN 50178 and CEI 61010-1 standards and following conditions :
• Over voltage category OV 3
• Pollution degree PD2
• Non-uniform field
dCp, dCI, Vw
Single isolation
Reinforced isolation
EN 50178
Rated isolation voltage
5000 V
2500 V
CEI 61010-1
Nominal voltage
Cat IIIa 5000 V rms
Cat IIIa 2500 V rms
Safety
This transducer must be used in electric/electronic equipment with respect to
applicable standards and safety requirements in accordance with the following
manufacturer's operating instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can carry hazardous
voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious damage.
This transducer is a built-in device, whose conducting parts must be inaccessible
after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
LEM Components
050816/1
Page 2/3
w w w.lem.com
Share Link: 