M25P20 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
M25P20 Datasheet PDF : 50 Pages
| |||
M25P20
Instructions
Table 7. Protection Modes
W SRWD
Signal Bit
Mode
Write Protection of the
Status Register
Memory Content
Protected Area(1)
Unprotected
Area(1)
1
0
Status Register is Writable
0
1
0
1
(if the WREN instruction
Software has set the WEL bit)
Protected
(SPM) The values in the SRWD,
BP1 and BP0 bits can be
Protected against
Page Program,
Sector Erase and
Bulk Erase
Ready to accept
Page Program and
Sector Erase
instructions
changed
Status Register is
0
1
Hardware Hardware write protected
Protected The values in the SRWD,
(HPM) BP1 and BP0 bits cannot
Protected against
Page Program,
Sector Erase and
Bulk Erase
Ready to accept
Page Program and
Sector Erase
instructions
be changed
1. As defined by the values in the Block Protect (BP1, BP0) bits of the Status Register, as shown in Table 2.
The protection features of the device are summarized in Table 7.
When the Status Register Write Disable (SRWD) bit of the Status Register is 0 (its initial
delivery state), it is possible to write to the Status Register provided that the Write Enable
Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction, regardless
of the whether Write Protect (W) is driven High or Low.
When the Status Register Write Disable (SRWD) bit of the Status Register is set to 1, two
cases need to be considered, depending on the state of Write Protect (W):
● If Write Protect (W) is driven High, it is possible to write to the Status Register provided
that the Write Enable Latch (WEL) bit has previously been set by a Write Enable
(WREN) instruction.
● If Write Protect (W) is driven Low, it is not possible to write to the Status Register even
if the Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN)
instruction. (Attempts to write to the Status Register are rejected, and are not accepted
for execution). As a consequence, all the data bytes in the memory area that are
software protected (SPM) by the Block Protect (BP1, BP0) bits of the Status Register,
are also hardware protected against data modification.
Regardless of the order of the two events, the Hardware Protected Mode (HPM) can be
entered:
● by setting the Status Register Write Disable (SRWD) bit after driving Write Protect (W)
Low
● or by driving Write Protect (W) Low after setting the Status Register Write Disable
(SRWD) bit.
The only way to exit the Hardware Protected Mode (HPM) once entered is to pull Write
Protect (W) High.
If Write Protect (W) is permanently tied High, the Hardware Protected Mode (HPM) can
never be activated, and only the Software Protected Mode (SPM), using the Block Protect
(BP1, BP0) bits of the Status Register, can be used.
23/50
Share Link: 