MB1507 查看數據表（PDF） - Fujitsu

零件编号

产品描述 (功能)

生产厂家

MB1507

SERIAL INPUT PLL FREQUENCY SYNTHESIZER

Fujitsu 

MB1507

PIN DESCRIPTION

Pin No.

Pin Name

I/O

Description

1

OSCIN

I Oscillator input.

2

OSCOUT

O Oscillator output.

A crystal is placed between OSCIN and OSCOUT.

3

VP

– Power supply input for charge pump and analog switch.

4

VCC

– Power supply voltage input.

Charge pump output.

5

DO

O The characteristics of charge pump is reversed depending upon FC input.

6

GND

– Ground.

Phase comparator output.

7

LD

O Normally the output level is high level. While the phase difference of fr and fp exists, the output be-

comes low level.

Prescaler input.

8

fIN

I The connection with VCO should be AC connection.

9

Clock

I

Clock input for 20-bit shift register and 16-bit shift register.

On rising edge of the clock shifts one bit of data into the shift registers.

Binary serial data input.

The last bit of the data is a control bit which specified destination of shift registers. When this bit is

10

Data

I high level and LE is high level, the data stored in shift register is transferred to 15-bit latch. When

this bit is low level and LE is high level, the data is transferred to 19-bit latch.

Load enable input (with pull up resistor).

11

LE

I When LE is high or open, the data stored in shift register is transferred into latch depending upon the

control bit. At the time, internal charge pump output to be connected to BISW pin because internal

analog switch becomes ON state.

Phase select input of phase comparator (with pull up resistor).

12

FC

I When FC is low level, the characteristics of charge pump, phase comparator is reversed.

FC pin input signal controls fout pin (test pin) output level, fr or fp.

Analog switch output.

13

BISW

O Usually BISW pin is set high-impedance state. When internal analog switch is ON (LE pin is high

level), this pin outputs internal charge pump output.

Monitor pin of phase comparator input.

fout pin outputs programmable reference divider output (fr) or programmable divider output (fp) de-

14

fOUT

O pending upon FC pin input level.

FC=H: It is the same as fr output level.

FC=L: It is the same as fp output level.

15

ØP

O Outputs for external charge pump.

16

ØR

O The characteristics are reversed according to FC input.

∅P pin is N-channel open drain output.

3

Share Link: