MB89120/120A Series
s MASK OPTIONS
Part number
No.
Specifying procedure
MB89121
MB89123A
MB89125A
MB89P131
MB89P133A
Specify when ordering
masking
MB89P135A
Set with EPROM
programmer
MB89PV130A
Specification
impossible
Pull-up resistors
1 • P00 to P07, P10 to P17,
• P30 to P37, P40 to P43
Selectable by pin
All pins fixed to
Selectable by pin (P40 to P43 must be set to without no pull-up resis-
a pull-up resistor.)
tor optional
Power-on reset
2 Power-on reset provided
No power-on reset
Selectable
Selectable
Selectable
With power-on
reset
Selection of oscillation stabiliza-
tion wait time
• The oscillation stabilization wait
time initial value is selectable
3 from 4 types given below.
Selectable
0 : Oscillation stabilization 22/FCH
1 : Oscillation stabilization 212/FCH
2 : Oscillation stabilization 216/FCH
3 : Oscillation stabilization 218/FCH
Selectable
Selectable
Oscillation sta-
bilization
218/FCH
Reset pin output
4 • Reset output provided
• No reset output
Selectable
Selectable
Selectable
With reset out-
put
Clock mode selection
5 • Single-clock mode
• Dual-clock mode
Selectable
Selectable
Selectable
Dual-clock
mode
Main clock oscillation circuit type
6 • External clock input
Selectable
• Oscillation resonator
Not required*1
Peripheral control clock
7
output function*2
• Not used
• Used
Selectable
Not required*3
*1 : Both external clock and oscillation resonator is usable on the one-time product.
*2 : “Used” must be selected when P33 (39 pin) is used as SCO for the peripheral control clock output.
*3 : The peripheral control clock function can be used only by software.
44