CXA3090N
Notes on operation
• This device handles high frequency and high gain signals. Please note the following;
♦ Connect VCC decoupling capacitor of approximately 1000 pF near the device.
♦ Make the GND area as large as possible.
• When using as 2 or 4-channel, short-circuit the X and Y sides of unused head pins or leave them open.
• The WC pin is a constant voltage pin. When noise affects this pin, it creates noise in Write c current.
Therefore, locate RWC as close to the device as possible.
• Write unsafe detection circuit
This circuit uses the voltage waveforms of the head pins for detection.
Wave form of write data
Voltage waveform
of head pins (HX, HY)
VFB
VTH=1.4V
VTH
GND
♦ VFB must be more than 2 V. When VFB < 2 V, it is possible that Write unsafe detection maximum
frequency becomes more than 1 MHz.
♦ The normal operating area of write unsafe detection circuit is changed by head inductance, head DC
resistance, write current and other.
—14—