A29L008TV-70 查看數據表（PDF） - AMIC Technology
零件编号
产品描述 (功能)
生产厂家
A29L008TV-70 Datasheet PDF : 36 Pages
| |||
Timing Waveforms for Alternate CE Controlled Write Operation
555 for program
2AA for erase
PA for program
SA for sector erase
555 for chip erase
Data Polling
Addresses
PA
tWC
tAS
tWH
tAH
WE
OE
tCP
tWHWH1 or 2
CE
tWS
Data
tCPH
tDS
tDH
tBUSY
I/O7
tRH
RESET
A0 for program
55 for erase
PD for program
30 for sector erase
10 for chip erase
RY/BY
A29L008 Series
DOUT
Note :
1. PA = Program Address, PD = Program Data, SA = Sector Address, I/O 7 = Complement of Data Input, D OUT = Array Data.
2. Figure indicates the last two bus cycles of the command sequence.
Erase and Programming Performance
Parameter
Sector Erase Time
Chip Erase Time
Programming Time
Chip Programming Time (Note 3)
Typ. (Note 1)
1.0
35
35
11
Max. (Note 2)
8
300
33
Unit
Comments
sec Excludes 00h programming
sec prior to erasure
µs
Excludes system-level
sec overhead (Note 5)
Notes:
1. Typical program and erase times assume the following conditions: 25°C, 3.0V VCC, 10,000 cycles. Additionally,
programming typically assumes checkerboard pattern.
2. Under worst case conditions of 90°C, VCC = 2.7V, 100,000 cycles.
3. The typical chip programming time is considerably less than the maximum chip programming time listed, since most
program faster than the maximum program time listed. If the maximum program time given is exceeded, only then does
the device set I/O5 = 1. See the section on I/O5 for further information.
4. In the pre-programming step of the Embedded Erase algorithm, all bytes are programmed to 00h before erasure.
5. System-level overhead is the time required to execute the four-bus-cycle command sequence for programming. See
Table 5 for further information on command definitions.
6. The device has a guaranteed minimum erase and program cycle endurance of 10,000 cycles.
PRELIMINARY (November, 2002, Version 0.0)
32
AMIC Technology, Corp.
Share Link: 