P89LPC914FDH 查看數據表（PDF） - Philips Electronics

零件编号

产品描述 (功能)

生产厂家

P89LPC914FDH

8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM

Philips Electronics 

Philips Semiconductors

P89LPC912/913/914

8-bit microcontrollers with two-clock 80C51 core

• Serial Flash In-Circuit Programming (ICP) allows simple production coding with

commercial EPROM programmers. Flash security bits prevent reading of sensitive

application programs.

• Watchdog timer with separate on-chip oscillator, requiring no external

components. The watchdog prescaler is selectable from 8 values.

• Low voltage reset (Brownout detect) allows a graceful system shutdown when

power fails. May optionally be configured as an interrupt.

• Idle and two different Power-down reduced power modes. Improved wake-up from

Power-down mode (a low interrupt input starts execution). Typical Power-down

current is 1 µA (total Power-down with voltage comparators disabled).

• Active-LOW reset. On-chip power-on reset allows operation without external reset

components. A reset counter and reset glitch suppression circuitry prevent

spurious and incomplete resets. A software reset function is also available.

• Configurable on-chip oscillator with frequency range options selected by user

programmed Flash configuration bits. Oscillator options support frequencies from

20 kHz to the maximum operating frequency of 18 MHz (P89LPC912,

P89LPC913).

• Oscillator Fail Detect. The watchdog timer has a separate fully on-chip oscillator

allowing it to perform an oscillator fail detect function.

• Programmable port output configuration options: quasi-bidirectional, open drain,

push-pull, input-only.

• Port ‘input pattern match’ detect. Port 0 may generate an interrupt when the value

of the pins match or do not match a programmable pattern.

• LED drive capability (20 mA) on all port pins. A maximum limit is specified for the

entire chip.

• Controlled slew rate port outputs to reduce EMI. Outputs have approximately 10 ns

minimum ramp times.

• Only power and ground connections are required to operate the

P89LPC912/913/914 when internal reset option is selected.

• Four interrupt priority levels.

• Four keypad interrupt inputs.

• Second data pointer.

• Schmitt trigger port inputs.

• Emulation support.

9397 750 14468

Product data

Rev. 03 — 17 December 2004

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

2 of 63

Share Link: