PCA9535A 查看數據表（PDF） - NXP Semiconductors.

零件编号

产品描述 (功能)

生产厂家

PCA9535A

Low-voltage 16-bit I2C-bus I/O port with interrupt

NXP Semiconductors. 

NXP Semiconductors

PCA9535A

Low-voltage 16-bit I2C-bus I/O port with interrupt

8. Application design-in information

VDD

(3.3 V)

VDD

MASTER

CONTROLLER

SCL

SDA

INT

VSS

10 kΩ

10 kΩ

10 kΩ

VDD

PCA9535A

SCL

SDA

INT

P0_0

P0_1

P0_2

P0_3

P0_4

P0_5

P0_6

P0_7

P1_0

P1_1

P1_2

P1_3

P1_4

A2

P1_5

A1

P1_6

A0

P1_7

VSS

2 kΩ

100 kΩ

(×3)

SUB-SYSTEM 1(1)

(e.g., temp sensor)

INT

10 DIGIT

NUMERIC

KEYPAD

SUB-SYSTEM 2

(e.g., counter)

RESET

A

enable

controlled

switch

(e.g., CBT device)

B

SUB-SYSTEM 3(1)

(e.g., alarm system)

ALARM

VDD

002aag212

Device address configured as 0100 000X for this example.

P0_0, P0_2, P0_3 configured as outputs.

P0_1, P0_4, P0_5 configured as inputs.

P0_6, P0_7 and (P1_0 to P1_7) configured as inputs.

(1) External resistors are required for inputs (on P port) that may float. If a driver to an input will never let the input float, a resistor

is not needed. If an output in the P port is configured as a push-pull output there is no need for external pull-up resistors. If an

output in the P port is configured as an open-drain output, external pull-up resistors are required.

Fig 12. Typical application

8.1 Minimizing IDD when the I/Os are used to control LEDs

When the I/Os are used to control LEDs, they are normally connected to VDD through a

resistor as shown in Figure 12. Since the LED acts as a diode, when the LED is off the I/O

VI is about 1.2 V less than VDD. The supply current, IDD, increases as VI becomes lower

than VDD.

Designs needing to minimize current consumption, such as battery power applications,

should consider maintaining the I/O pins greater than or equal to VDD when the LED is off.

Figure 13 shows a high value resistor in parallel with the LED. Figure 14 shows VDD less

than the LED supply voltage by at least 1.2 V. Both of these methods maintain the I/O VI

at or above VDD and prevents additional supply current consumption when the LED is off.

PCA9535A

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 1 — 11 September 2012

© NXP B.V. 2012. All rights reserved.

14 of 38

Share Link: