PCA9539A 查看數據表（PDF） - NXP Semiconductors.

零件编号

产品描述 (功能)

生产厂家

PCA9539A

Low-voltage 16-bit I2C-bus I/O port with interrupt and reset

NXP Semiconductors. 

NXP Semiconductors

PCA9539A

Low voltage 16-bit I2C-bus I/O port with interrupt and reset

6.5 RESET input

The RESET input can be asserted to initialize the system while keeping the VDD at its

operating level. A reset can be accomplished by holding the RESET pin LOW for a

minimum of tw(rst). The PCA9539A registers and I2C-bus/SMBus state machine are

changed to their default state once RESET is LOW (0). When RESET is HIGH (1), the I/O

levels at the ports can be changed externally or through the master. This input requires a

pull-up resistor to VDD if no active connection is used.

6.6 Interrupt output

An interrupt is generated by any rising or falling edge of the port inputs in the Input mode.

After time tv(INT), the signal INT is valid. The interrupt is reset when data on the port

changes back to the original value or when data is read form the port that generated the

interrupt (see Figure 10). Resetting occurs in the Read mode at the acknowledge (ACK)

or not acknowledge (NACK) bit after the rising edge of the SCL signal. Interrupts that

occur during the ACK or NACK clock pulse can be lost (or be very short) due to the

resetting of the interrupt during this pulse. Any change of the I/Os after resetting is

detected and is transmitted as INT.

A pin configured as an output cannot cause an interrupt. Changing an I/O from an output

to an input may cause a false interrupt to occur, if the state of the pin does not match the

contents of the Input Port register.

The INT output has an open-drain structure and requires pull-up resistor to VDD.

7. Bus transactions

The PCA9539A is an I2C-bus slave device. Data is exchanged between the master and

PCA9539A through write and read commands using I2C-bus. The two communication

lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be

connected to a positive supply via a pull-up resistor when connected to the output stages

of a device. Data transfer may be initiated only when the bus is not busy.

7.1 Writing to the port registers

Data is transmitted to the PCA9539A by sending the device address and setting the least

significant bit to a logic 0 (see Figure 4 “PCA9539A device address”). The command byte

is sent after the address and determines which register will receive the data following the

command byte.

Eight registers within the PCA9539A are configured to operate as four register pairs. The

four pairs are input port, output port, polarity inversion, and configuration registers. After

sending data to one register, the next data byte is sent to the other register in the pair (see

Figure 7 and Figure 8). For example, if the first byte is sent to Output Port 1 (register 3),

the next byte is stored in Output Port 0 (register 2).

There is no limitation on the number of data bytes sent in one write transmission. In this

way, the host can continuously update a register pair independently of the other registers,

or the host can simply update a single register.

PCA9539A

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 1 — 26 September 2012

© NXP B.V. 2012. All rights reserved.

9 of 39

Share Link: