T83C5101XXX-TIRCV(2003) 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

T83C5101XXX-TIRCV
(Rev.:2003)

8-bit Low Pin Count Microcontrollers

Atmel Corporation 

T8xC5101/02

Figure 5. Auto-Reload Mode Up/Down Counter (DCEN = 1)

XTAL1

FXTAL

FOSC

(:6 in X2 mode)

:12

0

1

T2

C/T2

TR2

T2CONreg T2CONreg

(DOWN COUNTING RELOAD VALUE)

FFh FFh

(8-bit) (8-bit)

T2EX:

if DCEN=1, 1=UP

if DCEN=1, 0=DOWN

if DCEN = 0, up

counting

TOGGLE T2CONreg

EXF2

TL2 TH2

(8-bit) (8-bit)

TF2

TIMER 2

INTERRUPT

T2CONreg

RCAP2L RCAP2H

(8-bit) (8-bit)

(UP COUNTING RELOAD VALUE)

Programmable Clock-Output

In the clock-out mode, timer 2 operates as a 50%-duty-cycle, programmable clock gen-

erator (See Figure 6) . The input clock increments TL2 at frequency FOSC/2. The timer

repeatedly counts to overflow from a loaded value. At overflow, the contents of RCAP2H

and RCAP2L registers are loaded into TH2 and TL2. In this mode, timer 2 overflows do

not generate interrupts. The formula gives the clock-out frequency as a function of the

system oscillator frequency and the value in the RCAP2H and RCAP2L registers:

Clock – OutFrequency

=

-------------------------------F----o----s---c-----×-----2---x----2--------------------------------

4 × (65536 – RCAP2H ⁄ RCAP2L)

For a 16 MHz system clock, timer 2 has a programmable frequency range of 61 Hz

(FOSC/216) to 4 MHz (FOSC/4) in X1 mode. The generated clock signal is brought out to

T2 pin (P1.0).

Timer 2 is programmed for the clock-out mode as follows:

• Set T2OE bit in T2MOD register.

• Clear C/T2 bit in T2CON register.

• Determine the 16-bit reload value from the formula and enter it in RCAP2H/RCAP2L

registers.

• Enter a 16-bit initial value in timer registers TH2/TL2. It can be the same as the

reload value or a different one depending on the application.

• To start the timer, set TR2 run control bit in T2CON register.

15

4233G–8051–03/03

Share Link: