Philips Semiconductors
Advanced pager receiver
Product specification
UAA2082
AC CHARACTERISTICS (173 MHz)
VP = 2.05 V; Tamb = 25 °C; test circuit Figs 1 or 2; fi(RF) = 172.941 MHz with ±4.0 kHz deviation; 1200 baud pseudo
random bit sequence modulation (tr = 250 ±25 µs measured between 10% and 90% of voltage amplitude) and 20 kHz
channel spacing; unless otherwise specified.
SYMBOL
PARAMETER
CONDITIONS
MIN. TYP. MAX. UNIT
Radio frequency input
Pi(ref)
input sensitivity (Pi(ref) is the
maximum available power at
the RF input of the test board)
BER ≤ 3⁄100; note 1
Tamb = −10 to +70 °C; note 2
VP = 1.9 V
Mixers to demodulator
αacs
αci
αc
αsp
αim
αbl
foffset
∆fdev
adjacent channel selectivity
IF filter channel imbalance
Tamb = 25 °C
Tamb = −10 to +70 °C
co-channel rejection
spurious immunity
intermodulation immunity
blocking immunity
∆f > ±1 MHz; note 3
frequency offset range
deviation f = ±4.0 kHz
(3 dB degradation in sensitivity) deviation f = ±4.5 kHz
deviation range
(3 dB degradation in sensitivity)
ton
receiver turn-on time
data valid after setting RE input
HIGH; note 4
−
−
−
69
67
−
−
50
55
78
±2.0
±2.5
2.5
−
−126.5
−
−
−123.5
−120.5
−117.5
dBm
dBm
dBm
72
−
dB
−
−
dB
−
2
dB
4
7
dB
60
−
dB
60
−
dB
85
−
dB
−
−
kHz
−
−
kHz
−
7.0
kHz
−
5
ms
Notes
1. The bit error rate BER is measured using the test facility shown in Fig.12. Note that the BER test facility contains a
digital input filter equivalent to the one used in the PCA5000A, PCF5001 and PCD5003 POCSAG decoders.
2. Capacitor C16 requires re-adjustment to compensate temperature drift.
3. ∆f is the frequency offset between the required signal and the interfering signal.
4. Turn-on time is defined as the time from pin RE going HIGH to the reception of valid data on output pin DO. Turn-on
time is measured using an external oscillator (turn-on time using the internal oscillator is dependent upon the
oscillator circuitry).
1996 Jan 15
21