W83L784G 查看數據表（PDF） - Winbond

零件编号

产品描述 (功能)

生产厂家

W83L784G

Winbond H/W Monitoring IC

Winbond 

W83L784R/ W83L784G

6.5.3 Smart Fan Control

Smart Fan Control provides two mechanisms. One is Thermal Cruise mode and the other is Fan

Speed Cruise mode.

6.5.3.1. Thermal Cruise mode

At this mode, W83L784R/G provides the Smart Fan system which can control the fan speed

automatically depend on current temperature to keep it with in a specific range. At first a wanted

temperature and interval must be set (ex. 55 °C ± 3 °C) by BIOS, as long as the current temperature

remains below the setting value, the fan will be off. Once the temperature exceeds the setting high

limit temperature (58°C), the fan will be turned on with a specific speed set by BIOS (ex: 80% duty

cycle) and automatically controlled its PWM duty cycle with the temperature varying. Three conditions

may occur:

(1) If the temperature still exceeds the high limit (ex: 58°C), PWM duty cycle will increase slowly. If the

fan has been operating in its fully speed but the temperature still exceeds the high limit (ex: 58°C), a

warning message or a fan_fault signal(pin5) will be issued to protect the system.

(2) If the temperature goes below the high limit (ex: 58°C), but above the low limit (ex: 52°C), the fan

speed will be fixed at the current speed because the temperature is in the target area (ex: 52 °C ~

58°C).

(3) If the temperature goes below the low limit (ex: 52°C), PWM duty cycle will decrease slowly to 0 or

a preset value until the temperature exceeds the low limit.

Figure 17 gives an illustration for Thermal Cruise Mode.

58`C

55`C

52`C

A

B

PWM 100

Duty

Cycle 50

0

Fan Start = 20%

C

D

Figure 17-1

- 16 -

Publication Release Date: Jan. 2005

Revision 1.1

Share Link: