WM2618ID 查看數據表（PDF） - Wolfson Microelectronics plc
零件编号
产品描述 (功能)
生产厂家
WM2618ID Datasheet PDF : 10 Pages
| |||
Production Data
WM2618
SOFTWARE CONFIGURATION OPTIONS
The 16 bits of data can be transferred with the sequence shown in Table 2. D11-D0 contains the 12-
bit data word. D15-D12 hold the programmable options which are summarized in Table 3.
D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
Program Bits
New DAC value
Table 2 Serial Word Format
PROGRAM BITS
DEVICE FUNCTION
D15
D14
D13
D12
1
X
X
X
Write to latch A with serial interface register data and
latch B updated with buffer latch data.
0
X
X
0
Write to latch B and double buffer latch.
0
X
X
1
Write to double buffer latch only.
X
0
X
X
12µs settling time.
X
1
X
X
4µs settling time.
X
X
0
X
Powered-up operation.
X
X
1
X
Power down mode.
Table 3 Program Bits D15 to D12 Function
PROGRAMMABLE SETTLING TIME
Settling time is a software selectable 12µs or 4µs, typical to within ±0.5LSB of final value.
This is controlled by the value of D14. A ONE defines a settling time of 4µs, a ZERO defines
a settling time of 12µs.
PROGRAMMABLE POWER DOWN
The power down function is controlled by D13. A ZERO configures the device as active, or
fully powered up, a ONE configures the device into power down mode. When the power
down function is released the device reverts to the DAC code set prior to power down.
FUNCTION OF THE LATCH CONTROL BITS (D15 AND D12)
PURPOSE AND USE OF THE DOUBLE BUFFER
Normally only one DAC output can change after a write. The double buffer allows both DAC
outputs to change after a single write. This is achieved by the two following steps.
• A double buffer only write is executed to store the new DAC B data without changing the
DAC A and B outputs.
• Following the previous step, a write to latch A is executed. This writes the serial interface
register (SIR) data to latch A and also writes the double buffer contents to latch B. Thus
both DACs receive their new data at the same time and so both DAC outputs begin to
change at the same time.
Unless a double buffer only write is issued, the latch B and double buffer contents are
identical. Thus, following a write to latch A or B with another write to latch A does not change
the latch B contents.
Three data transfer options are possible. All transfers occur immediately after NCS goes high
(or on the sixteenth positive SCLK edge, whichever is earlier) and are described in the
following sections.
LATCH A WRITE, LATCH B UPDATE (D15 = HIGH, D12 = X)
The serial interface register (SIR) data are written to latch A and the double buffer latch
contents are written to latch B. The double buffer contents are unaffected. This program bit
condition allows simultaneous output updates of both DACs.
WOLFSON MICROELECTRONICS LTD
PD Rev 1.1 October 2000
7
Share Link: 