DS1621 查看數據表（PDF） - Dallas Semiconductor -> Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

DS1621

Digital Thermometer and Thermostat

Dallas Semiconductor -> Maxim Integrated 

NOTES:

1. All voltages are referenced to ground.

DS1621

2. I/O pins of fast mode devices must not obstruct the SDA and SCL lines if VDD is switched off.

3. ICC specified with TOUT pin open.

4. ICC specified with VCC at 5.0V and SDA, SCL = 5.0V, 0°C to 70°C.

5. After this period, the first clock pulse is generated.

6. A device must internally provide a hold time of at least 300 ns for the SDA signal (referred to the

VIH MIN of the SCL signal) in order to bridge the undefined region of the falling edge of SCL.

7. The maximum tHD:DAT has only to be met if the device does not stretch the LOW period (tLOW) of the

SCL signal.

8. A fast mode device can be used in a standard mode system, but the requirement tSU:DAT >250 ns must

then be met. This will automatically be the case if the device does not stretch the LOW period of the

SCL signal. If such a device does stretch the LOW period of the SCL signal, it must output the next

data bit to the SDA line tRMAX+tSU:DAT = 1000+250 = 1250 ns before the SCL line is released.

9. Cb – total capacitance of one bus line in pF.

10. Writing to the nonvolatile memory should only take place in the 0°C to 70°C temperature range.

11. See typical curve for specification limits outside 0°C to 70°C range. Thermometer error reflects

sensor accuracy as tested during calibration.

TIMING DIAGRAM

15 of 16

102299

Share Link: