MAX7490CEE 查看數據表（PDF） - Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

MAX7490CEE

Dual Universal Switched-Capacitor Filters

Maxim Integrated 

Dual Universal Switched-Capacitor Filters

SHDN (6)

VDD (8)

R

INVA (4)

COM (11)

R

GND (7)

CLK (9)

EXTCLK (10)

INVB (13)

NA/HPA (3)

+

Σ

-

NB/HPB (14) SA (5)

+

Σ

-

SB (12)

BPA (2)

LPA (1)

∫

∫

BPB (15)

LPB (16)

∫

∫

Figure 1. Block Diagram

2nd-Order Filter Stage

The MAX7490/MAX7491 are dual biquad filters. The

biquad topology allows the use of standard filter tables

and equations to implement simultaneous lowpass,

bandpass, and notch or highpass filters. Topologies

such as Butterworth, Chebyshev, Bessel, elliptic, as

well as custom algorithms are possible.

Internal Common Voltage

The COM pin sets the common-mode input voltage and

is internally biased to VDD/2 with a resistor-divider. The

resistors used are typically 250kΩ for the MAX7490,

and typically 80kΩ for the MAX7491. The common-

mode voltage is easily overdriven by an external volt-

age supply if desired. Bypass COM to the analog

ground with at least a 0.1µF capacitor.

Inverting Inputs

Locate resistors that are connected to INV_ as close as

possible to INV_ to reduce stray capacitance and noise

pickup. INV_ are inverting inputs to continuous-time op

amps, and behave like a virtual ground. There is no

sampling energy present on these inputs.

Outputs

Each switched-capacitor section, together with two to

four external resistors, can generate all standard 2nd-

order functions: bandpass, lowpass, highpass, and

notch (band-reject) functions. Three of these functions

are simultaneously available. The maximum signal

swing is limited by the power-supply voltages used.

The amplifiers’ outputs in the MAX7490/MAX7491 are

able to swing to within approximately 0.2V of either

supply.

Driving coaxial cable, large capacitive loads, or total

resistive loads less than 10kΩ will degrade the total

harmonic distortion (THD) performance. Note that the

effective resistive load at the output must include both

the feedback resistors and any external load resistors.

Low-Power Shutdown Mode

The MAX7490/MAX7491 have a shutdown mode that is

activated by driving SHDN low. In shutdown mode, the

filter supply current reduces to < 1µA (max), and the fil-

ter outputs become high impedance. The COM input

also becomes high impedance during shutdown. For

normal operation, drive SHDN high or connect to VDD.

__________Applications Information

Designing with the MAX7490/MAX7491 begins by

selecting the mode that best fits the desired circuit

requirements. Table 1 lists the available modes and

their relative advantages and disadvantages. Table 2

lists the different nomenclature used in the explanations

that follow.

_______________________________________________________________________________________ 9

Share Link: