LT1881 查看數據表（PDF） - Linear Technology
零件编号
产品描述 (功能)
生产厂家
LT1881 Datasheet PDF : 18 Pages
| |||
LT1881/LT1882
APPLICATIONS INFORMATION
The LT1881 dual and LT1882 quad op amps feature
exceptional input precision with rail-to-rail output swing.
The amplifiers are similar to the LT1884 and LT1885
devices. The LT1881 and LT1882 offer superior capacitive
load driving capabilities over the LT1884 and LT1885 in low
voltage gain configurations. Offset voltages are trimmed to
less than 50μV and input bias currents are less than 200pA
on the “A” grade devices. Obtaining beneficial advantage of
these precision input characteristics depends upon proper
applications circuit design and board layout.
Preserving Input Precision
Preserving the input voltage accuracy of the LT1881/LT1882
requires that the applications circuit and PC board layout
do not introduce errors comparable to or greater than the
30μV offset. Temperature differentials across the input
connections can generate thermocouple voltages of 10’s
of microvolts. PC board layouts should keep connections
to the amplifier’s input pins close together and away from
heat dissipating components. Air currents across the board
can also generate temperature differentials.
The extremely low input bias currents, 150pA, allow high
accuracy to be maintained with high impedance sources
and feedback networks. The LT1881/LT1882’s low input
bias currents are obtained by using a cancellation circuit
on-chip. This causes the resulting IBIAS+ and IBIAS– to
be uncorrelated, as implied by the IOS specification being
greater than the IBIAS. The user should not try to balance
the input resistances in each input lead, as is commonly
recommended with most amplifiers. The impedance at
either input should be kept as small as possible to minimize
total circuit error.
PC board layout is important to insure that leakage currents
do not corrupt the low IBIAS of the amplifier. In high
precision, high impedance circuits, the input pins should
be surrounded by a guard ring of PC board interconnect,
with the guard driven to the same common mode voltage
as the amplifier inputs.
Input Common Mode Range
The LT1881 and LT1882 outputs are able to swing nearly
to each power supply rail, but the input stage is limited
to operating between V– +1V and V+ –1V. Exceeding this
common mode range will cause the gain to drop to zero;
however, no phase reversal will occur.
Input Protection
The inverting and noninverting input pins of the LT1881
and LT1882 have limited on-chip protection. ESD protection
is provided to prevent damage during handling. The input
transistors have voltage clamping and limiting resistors
to protect against input differentials up to 10V. Short
transients above this level will also be tolerated. If the
input pins can see a sustained differential voltage above
10V, external limiting resistors should be used to prevent
damage to the amplifier. A 1k resistor in each input lead
will provide protection against a 30V differential voltage.
Capacitive Loads
The LT1881 and LT1882 can drive capacitive loads up to
1000pF in unity-gain. The capacitive load driving increases
as the amplifier is used in higher gain configurations.
Capacitive load driving may be increased by decoupling
the capacitance from the output with a small resistance.
18812fb
14
Share Link: 