TDA75610SEP 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

TDA75610SEP

4 x 45 W power amplifier with full I2C diagnostics, high efficiency and low voltage operation

STMicroelectronics 

TDA75610SEP

Diagnostics functional description

4

Diagnostics functional description



8YVRSRHMEKRSWXMG

It is recommended to activate this function at the turn-on (standby out) through an I2C bus

request. Detectable output faults are:

SHORT TO GND

SHORT TO VS

SHORT ACROSS THE SPEAKER

OPEN SPEAKER

To verify if any of the above misconnections are in place, a subsonic (inaudible) current

pulse (Figure 21) is internally generated, sent through the speaker(s) and sunk back.The

Turn On diagnostic status is internally stored until a successive diagnostic pulse is

requested (after a I2C reading).

If the "standby out" and "diag. enable" commands are both given through a single

programming step, the pulse takes place first (during the pulse the power stage stays 'off',

showing high impedance at the outputs).

Afterwards, when the amplifier is biased, the PERMANENT diagnostic takes place. The

previous turn-on state is kept until a short appears at the outputs.

Figure 21. Turn-on diagnostic: working principle

Figure 22 and 23 show SVR and OUTPUT waveforms at the turn-on (standby out) with and

without turn-on diagnostic.

Figure 22. SVR and output behavior (Case 1: without turn-on diagnostic)

DocIDXXXXXX Rev 1.3

17/39

38

Share Link: