MAX3086EEPD 查看數據表（PDF） - Maxim Integrated
零件编号
产品描述 (功能)
生产厂家
MAX3086EEPD
Maxim Integrated
MAX3086EEPD Datasheet PDF : 21 Pages
| |||
±15kV ESD-Protected, Fail-Safe, High-Speed (10Mbps),
Slew-Rate-Limited RS-485/RS-422 Transceivers
MAX3080/3089 FIG-19
MAX3080/3089 FIG-20
DI
5V/div
DI
5V/div
VA - VB
1V/div
VA - VB
1V/div
RO
5V/div
RO
5V/div
2µs/div
Figure 20. MAX3083E/MAX3084E/MAX3085E, and MAX3089E
with SRL = VCC, System Differential Voltage at 50kHz Driving
4000ft of Cable
DI
D
120Ω
B
DE
A
B
RO
R
RE
MAX3082E
D
MAX3085E
MAX3088E
MAX3089E (HALF-DUPLEX)
DI
Figure 22. Typical Half-Duplex RS-485 Network
A
R
DE RO RE
Driver Output Protection
Two mechanisms prevent excessive output current and
power dissipation caused by faults or by bus con-
tention. The first, a foldback current limit on the output
stage, provides immediate protection against short cir-
cuits over the whole common-mode voltage range (see
Typical Operating Characteristics). The second, a ther-
mal shutdown circuit, forces the driver outputs into a
high-impedance state if the die temperature becomes
excessive.
Line Length vs. Data Rate
The RS-485/RS-422 standard covers line lengths up to
4000 feet. For line lengths greater than 4000 feet, use
the repeater application shown in Figure 18.
Figures 19, 20, and 21 show the system differential volt-
age for the parts driving 4000 feet of 26AWG twisted-
pair wire at 110kHz into 120Ω loads.
1µs/div
Figure 21. MAX3086E/MAX3087E/MAX3088E, and MAX3089E
with SRL = GND, System Differential Voltage at 200kHz Driving
4000ft of Cable
120Ω
DE
B
B
A
D
DI
A
R
D
R
RO
RE
DI
DE RO RE
Typical Applications
The MAX3082E/MAX3085E/MAX3088E/MAX3089E
transceivers are designed for bidirectional data com-
munications on multipoint bus transmission lines.
Figures 22 and 23 show typical network applications
circuits. These parts can also be used as line repeaters,
with cable lengths longer than 4000 feet, as shown in
Figure 18.
To minimize reflections, the line should be terminated at
both ends in its characteristic impedance, and stub
lengths off the main line should be kept as short as
possible. The slew-rate-limited MAX3082E/MAX3085E,
and the two modes of the MAX3089E, are more tolerant
of imperfect termination.
______________________________________________________________________________________ 19
Share Link: