SAM7X512 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

SAM7X512

AT91SAM ARM-based Flash MCU

Atmel Corporation 

SAM7X512/256/128 Summary

7. Processor and Architecture

7.1 ARM7TDMI Processor

• RISC processor based on ARMv4T Von Neumann architecture

– Runs at up to 55 MHz, providing 0.9 MIPS/MHz

• Two instruction sets

– ARM high-performance 32-bit instruction set

– Thumb high code density 16-bit instruction set

• Three-stage pipeline architecture

– Instruction Fetch (F)

– Instruction Decode (D)

– Execute (E)

7.2 Debug and Test Features

• Integrated embedded in-circuit emulator

– Two watchpoint units

– Test access port accessible through a JTAG protocol

– Debug communication channel

• Debug Unit

– Two-pin UART

– Debug communication channel interrupt handling

– Chip ID Register

• IEEE1149.1 JTAG Boundary-scan on all digital pins

7.3 Memory Controller

• Programmable Bus Arbiter

– Handles requests from the ARM7TDMI, the Ethernet MAC and the Peripheral DMA

Controller

• Address decoder provides selection signals for

– Three internal 1 Mbyte memory areas

– One 256 Mbyte embedded peripheral area

• Abort Status Registers

– Source, Type and all parameters of the access leading to an abort are saved

– Facilitates debug by detection of bad pointers

• Misalignment Detector

– Alignment checking of all data accesses

– Abort generation in case of misalignment

• Remap Command

– Remaps the SRAM in place of the embedded non-volatile memory

– Allows handling of dynamic exception vectors

15

6120GS–ATARM–07-Apr-11

Share Link: