B41456 查看數據表（PDF） - TDK Corporation
零件编号
产品描述 (功能)
生产厂家
B41456 Datasheet PDF : 17 Pages
| |||
B41456, B41458
Compact 85 °C
Product safety
The table below summarizes the safety instructions that must be observed without fail. A detailed
description can be found in the relevant sections of chapter "General technical information".
Topic
Polarity
Reverse voltage
Mounting
position of screw-
terminal capacitors
Robustness of
terminals
Mounting of
single-ended
capacitors
Soldering
Soldering,
cleaning agents
Upper category
temperature
Passive
flammability
Safety information
Reference
chapter "General
technical information"
Make sure that polar capacitors are connected 1
with the right polarity.
"Basic construction of
aluminum electrolytic
capacitors"
Voltages polarity classes should be prevented by 3.1.6
connecting a diode.
"Reverse voltage"
Do not mount the capacitor with the terminals
11.1.
(safety vent) upside down.
"Mounting positions of
capacitors with screw
terminals"
The following maximum tightening torques must 11.3
not be exceeded when connecting screw
"Mounting torques"
terminals:
M5: 2.5 Nm
M6: 4.0 Nm
The internal structure of single-ended capacitors 11.4
might be damaged if excessive force is applied to "Mounting
the lead wires.
considerations for
Avoid any compressive, tensile or flexural stress. single-ended capacitors"
Do not move the capacitor after soldering to PC
board.
Do not pick up the PC board by the soldered
capacitor.
Do not insert the capacitor on the PC board with a
hole space different to the lead space specified.
Do not exceed the specified time or temperature 11.5
limits during soldering.
"Soldering"
Do not allow halogenated hydrocarbons to come 11.6
into contact with aluminum electrolytic capacitors. "Cleaning agents"
Do not exceed the upper category temperature. 7.2
"Maximum permissible
operating temperature"
Avoid external energy, such as fire or electricity. 8.1
"Passive flammability"
Please read Cautions and warnings and
Important notes at the end of this document.
Page 13 of 17
Share Link: 