TC9329FA 查看數據表（PDF） - Toshiba
零件编号
产品描述 (功能)
生产厂家
TC9329FA Datasheet PDF : 83 Pages
| |||
Description of Pin Function
TC9329FA/FB
Pin No. Symbol
Pin Name
Function and Operation
1 COM1/OT1
2 COM2/OT2
3 COM3/OT3
4 COM4/OT4
S1/OT5~
5~14
S10/OT14
P8-0/S13~
15~22
P9-3/S18
Output common signals to LCD panels.
Through a matrix with pins S1 to S22, a
maximum 88 segments can be
displayed.
LCD common
output/Output port
Three levels, VLCD, VEE, and GND, are
output at 62.5 Hz every 2 ms.
VEE is output after system reset and
CLOCK STOP are released, and a
common signal is output after the DISP
OFF bit is set to “0”.
These pins can be programmed as
output ports (Note 1).
LCD segment
output/Output port
Segment signal output terminals for
LCD panel. Together with COM1 to
COM4, a matrix is formed that can
display a maximum of 72 segments.
VEE is output after system reset and
CLOCK STOP are released, and a
common signal is output after the DISP
OFF bit is set to “0”.
All pins from S1 to S10 can be
programmed as output ports (Note 1),
and all pins from S11 to S18 as I/O
ports, in units of pins.
When the pins function as output ports,
VLCD pin potential and GND potential
are output to them. When the pins
function as I/O ports, drain output is
N-ch open. Because power is supplied
from VLCD for the I/O ports, up to VLCD
voltage (3 V) can be applied.
LCD segment
output/ I/O port 8, 9
These data ports (OT1 to OT14) are
incremented by 1 by instruction every
time data are accessed. Therefore, they
can be used for external memory
address signals, facilitating data
access.
Note: After system reset, the output
port pins are set to LCD output,
the I/O port pins to I/O port input.
Remarks
VLCD
VEE
VLCD
VLCD
VDD
Input
instruction
23~26 P1-0~P1-3 I/O port 1
The input and output of these 4 bit I/O
ports can be programmed in 1 bit units.
VDD
VDD
These pins can be programmed to be
pulled up or down. Thus, they can be
used as key input pins.
By altering the input of I/O ports set to
input, the CLOCK STOP mode or the
WAIT mode can be released, and the
MUTE bit of the MUTE pin can be set to
“1”.
RIN1
VDD
Note 1: When the LCD pin is set as an output port, the “H” level output is the doubled voltage VLCD. Therefore,
disconnect the voltage doubler boosting capacitor but connect the VLCD pin to the VDD pin.
4
2002-02-07
Share Link: 