M34C02-R 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M34C02-R

2 Kbit serial I²C bus EEPROM for DIMM serial presence detect

STMicroelectronics 

M34C02-R

Device operation

3.6

Setting the software write-protection

The M34C02-W has a hardware write-protection feature, using the Write Control (WC)

signal. This signal can be driven high or low, and must be held constant for the whole

instruction sequence. When Write Control (WC) is held high, the whole memory array

(addresses 00h to FFh) is write protected. When Write Control (WC) is held low, the write

protection of the memory array is dependent on whether software write-protection has been

set.

Software write-protection allows the bottom half of the memory area (addresses 00h to 7Fh)

to be permanently write protected irrespective of subsequent states of the Write Control

(WC) signal.

The write protection feature is activated by writing once to the Protection Register. The

Protection Register is accessed with the device select code set to 0110b (as shown in

) Table 2), and the E2, E1 and E0 bits set according to the states being applied on the E2, E1

t(s and E0 signals. As for any other write command, Write Control (WC) needs to be held low.

c Address and data bytes must be sent with this command, but their values are all ignored,

u and are treated as Don’t Care. Once the Protection Register has been written, the write

d protection of the first 128 Bytes of the memory is enabled, and it is not possible to unprotect

Pro t(s) these 128 Bytes, even if the device is powered off and on, and regardless the state of Write

Control (WC).

lete uc When the Protection Register has been written, the M34C02-W no longer responds to the

d device type identifier 0110b in either read or write mode.

bso Pro Figure 7. Result of setting the write protection

ct(s) - Obsolete Memory

Produ t(s) - O Area

FFh

Standard

Array

80h

7Fh

Standard

Array

00h

te c Default EEPROM memory area

le ustate before write access

OObbssoolete Prodto the Protect Register

FFh

Standard

Array

80h

7Fh

Write

Protected

Array

00h

State of the EEPROM memory

area after write access

to the Protect Register

AI01936C

13/29

Share Link: