OPB804 查看數據表（PDF） - TT Electronics.
零件编号
产品描述 (功能)
生产厂家
OPB804 Datasheet PDF : 4 Pages
| |||
Slotted Optical Switch
OPB804
Electrical Specifications
Absolute Maximum Ratings (TA = 25° C unless otherwise noted)
Storage Temperature Range
Operating Temperature Range
Lead Soldering Temperature
Input Diode
Input Diode Power Dissipation
Input Diode Forward D.C. Current, TA = 25°C
Input Diode Peak Forward Pulse Current, TA = 25°C (1µs pulse width, 300pps)
Phototransistor
Power Dissipation
Collector - Emitter Voltage
Emitter - Collector Voltage
-40°C to +100° C
-40°C to +85° C
260° C( 5)
75 mW ( 7)
50 mA( 7)
1A
100 mW ( 7)
30V
5.0V
Electrical Characteristics ( TA = 25°C )
SYMBOL
PARAMETER
MIN TYP
Input Diode (see OP140 or OP240 for additional information)
VF
Forward Voltage
IR
Reverse Current
- 1.25
-
-
MAX
1.70
-
UNITS
TEST CONDITIONS
V IF = 20 mA
- Not designed for reverse operation
Output Phototransistor (see OP550 for additional information)
V(BR)CEO
V(BR)ECO
ICEO
Collector-Emitter Breakdown Voltage
Emitter-Collector Breakdown Voltage
Collector Dark Current
30 -
-
V IC = 1 mA, EE = 0 mw/cm2
5.0 -
-
V IE = 100 µA, EE = 0 mw/cm2
-
-
100
nA VCE = 10 V, IF = 0, EE = 0 mw/cm2
Coupled
VCE(SAT) Collector-Emitter Saturation Voltage
-
- 0.40
V IC = 250 µA, IF = 20 mA
IC(ON) On-State Collector Current
0.5 5
-
mA VCE = 10 V, IF = 20 mA
Notes:
(1) Dot indicates # 3 collector lead side.
(2) Feature controlled at body.
(3) Cathode lead may be shorter.
(4) RMA flux recommended. Highly activated water soluble fluxes may attack plastic. Recommend trial to verify application.
(5) Maximum lead soldering temperature .060” [1.6mm] from case for 5 seconds with soldering iron.
(6) Plastic is soluble in chlorinated hydrocarbons and ketones. Methanol or isopropanol are recommended as cleaning agents.
(7) Derate linearly 1.67 mW/°C above 25° C.
(8) All parameters tested using pulse techniques.
(9) Do not connect input diode directly to a voltage source without an external current limiting resistor.
(10) Do not apply reverse voltage to LED. LED will be a 0V in reverse voltage and draw current as if a short.
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
TT Electronics | Optek Technology, Inc.
1645 Wallace Drive, Ste. 130, Carrollton, TX USA 75006 |Ph: +1 972 323 2200
www.ttelectronics.com | sensors@ttelectronics.com
Issue B 11/2016 Page 2
Share Link: 