BR24T1MFJ-3AM 查看數據表（PDF） - ROHM Semiconductor

零件编号

产品描述 (功能)

生产厂家

BR24T1MFJ-3AM

Serial EEPROM Series Standard EEPROM I2C BUS EEPROM (2-Wire)

ROHM Semiconductor 

BR24T1M-3AM

Datasheet

Cautions on Microcontroller Connection

1. RS

In I2C BUS, it is recommended that SDA port is of open drain input/output. However, when using CMOS input / output of

tri state to SDA port, insert a series resistance RS between the pull up resistor RPU and the SDA terminal of EEPROM.

This is to control over current that may occur when PMOS of the microcontroller and NMOS of EEPROM are turned ON

simultaneously. RS also plays the role of protecting the SDA terminal against surge. Therefore, even when SDA port is

open drain input/output, RS can be used.

RPU

RS

SCL

SDA

'H' output of microcontroller

ACK

'L' output of EEPROM

Microcontroller

EEPROM

Figure 46. I/O Circuit Diagram

Over current flows to SDA line by 'H'

output of microcontroller and 'L'

output of EEPROM.

Figure 47. Input / Output Collision Timing

2. Maximum Value of RS

The maximum value of RS is determined by the following relations.

(1) SDA rise time to be determined by the capacitance (CBUS) of bus line of SDA and RPU should be tR or lower.

Furthermore, AC timing should be satisfied even when SDA rise time is slow.

(2) The bus electric potential A to be determined by RPU and RS the moment when EEPROM outputs 'L' to SDA bus

should sufficiently secure the input 'L' level (VIL) of microcontroller including recommended noise margin of 0.1VCC.

VCC

RPU A

RS

VOL

IOL

Bus line

capacity

CBUS

VIL Micro controller

EEPROM

Figure 48. I/O Circuit Diagram

(V CC －VOL)×R S

RPU+RS

+ VOL+0.1V CC≦VIL

∴

RS

≦

VIL－VOL－0.1V CC

1.1V CC-VIL

× RPU

Ex.）VCC=3V VIL=0.3V CC VOL=0.4V RPU=20k Ω

RS

≦

0.3×3 －0.4－0.1×3

1.1×3 －0.3×3

×

20×10 3

≦ 1.67 [kΩ]

3. Minimum Value of RS

The minimum value of RS is determined by over current at bus collision. When over current flows, noises in power

source line and instantaneous power failure of power source may occur. When allowable over current is defined as I,

the following relation must be satisfied. Determine the allowable current in consideration of the impedance of power

source line in set and so forth. Set the over current to EEPROM at 10mA or lower.

'H' output

RPU

RS

'L'output

Over current I

Microcontroller

EEPROM

Figure 49. I/O Circuit Diagram

VCC

RS ≦

I

∴ RS

VCC

≧I

Ex.) Vcc=3V, I=10mA

RS

≧

3

10×10-3

≧ 300 [Ω]

www..rohm.com

© 2016 ROHM Co., Ltd. All rights reserved.

TSZ22111・15・001

21/28

TSZ02201-0GFG0G100430-1-2

08.Jul.2016 Rev.001

Share Link: