MX609DW 查看數據表（PDF） - MX-COM Inc
零件编号
产品描述 (功能)
生产厂家
MX609DW Datasheet PDF : 14 Pages
| |||
PCN/PCS Delta Modulation CODEC
6
3 External Components
MX609
XTAL/CLOCK
X1
R1
1
16
C2 C1
XTAL 2
15
ENCODER DATA CLOCK 3
14
ENCODER OUTPUT 4
13
DATA ENABLE 5 MX609DW 12
BIAS 6
11
ENCODER INPUT 7
10
C3
VSS 8
9
C4
VDD
VDD
CLOCK MODE 1
CLOCK MODE 2
C5
ALGORITHM
DECODER DATA CLOCK
DECODER INPUT
POWERSAVE
DECODER OUTPUT
Figure 2: Recommended External Components for Typical Application
R1 Note 1 1M 10%
C1 Note 2 33pF 20%
C2 Note 2 68pF 20%
C3 Note 3 1.0F 20%
C4 Note 4
1.0F
20%
C5 Note 5
1.0F
20%
X1 Note 6, 7 1.024MHz
Table 4: Recommended External Components for Typical Application
Notes:
1. Oscillator inverter bias resister
2. Xtal circuit load capacitor
3. Encoder input coupling capacitor. The drive source impedance to this input should be less than 100W.
Output idle channel noise levels will improve with even lower source impedance.
4. Bias decoupling capacitor
5. VDD decoupling capacitor
6. A 1.024MHz Xtal/Clock input will yield exactly 16/32/64kbps data clock rates. Xtal circuitry shown is in
accordance with MX-COM’s Xtal Oscillator Application Note.
7. For best results, a crystal oscillator design should drive the clock inverter input with signal levels of at
least 40% of VDD, peak to peak. Tuning fork crystals generally cannot meet this requirement. To obtain
crystal oscillator design assistance, please consult you crystal manufacturer.
4 General Description
The MX609 is a Continuously Variable Slope Delta Modulation (CVSD) Codec designed for use in cordless
telephones. The device is suitable for applications in delta multiplexers, switches and phones. Encoder input
and decoder output switched capacitor filters are incorporated on-chip.
Sampling clock rates can be programmed to 16, 32 or 64K bits/second from an internal clock generator or
externally injected in the 8 to 64K bits/second range. The internal clocks are derived from an on-chip
reference oscillator driven by an externally connected crystal. The sampling clock frequency is output for the
synchronization of external circuits.
The encoder has an enable function for use in multiplexer applications. When not enabled the encoder output
remains in a high-impedance “tri-state” mode.
Companding circuits may be operated with an externally selectable 3- or 4-bit algorithm. The device may be
put in standby mode when Powersave is selected.
1998 MX-COM, Inc.
www.mxcom.com Tel: 800 638 5577 336 744 5050 Fax: 336 744 5054
Doc. # 204800069.005
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA All Trademarks and service marks are held by their respective companies.
Share Link: 