PCF8575CTS/F1 查看數據表（PDF） - Philips Electronics

零件编号

产品描述 (功能)

生产厂家

PCF8575CTS/F1

Remote 16-bit I/O expander for I2C-bus

Philips Electronics 

Philips Semiconductors

Remote 16-bit I/O expander for I2C-bus

Product specification

PCF8575C

7 CHARACTERISTICS OF THE I2C-BUS

The I2C-bus is for bidirectional, 2-line communication

between different ICs or modules. The two lines are a

serial data line (SDA) and a serial clock line (SCL). Both

lines must be connected to a positive supply via a pull-up

resistor when connected to the output stages of a device.

Data transfer may be initiated only when the bus is not

busy.

7.1 Bit transfer

One data bit is transferred during each clock pulse. The

data on the SDA line must remain stable during the HIGH

period of the clock pulse as changes in the data line at this

time will be interpreted as control signals (see Fig.9).

7.2 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not

busy. A HIGH-to-LOW transition of the data line, while the

clock is HIGH is defined as the START condition (S).

A LOW-to-HIGH transition of the data line while the clock

is HIGH is defined as the STOP condition P (see Fig.10).

7.4 Acknowledge

The number of data bytes transferred between the START

and the STOP conditions from transmitter to receiver is not

limited. Each byte of eight bits is followed by one

acknowledge bit. The transmitter must release the SDA

line before the receiver can send an acknowledge bit.

A slave receiver which is addressed must generate an

acknowledge after the reception of each byte. Also a

master must generate an acknowledge after the reception

of each byte that has been clocked out of the slave

transmitter. The device that acknowledges has to pull

down the SDA line during the acknowledge clock pulse, so

that the SDA line is stable LOW during the HIGH period of

the acknowledge related clock pulse, set-up and hold

times must be taken into account.

A master receiver must signal an end of data to the

transmitter by not generating an acknowledge after the

last byte that has been clocked out of the slave. This is

done by the master receiver by holding the SDA line HIGH.

In this event the transmitter must release the data line to

enable the master to generate a STOP condition.

7.3 System configuration

A device generating a message is a ‘transmitter’, a device

receiving the message is the ‘receiver’. The device that

controls the message is the ‘master’ and the devices which

are controlled by the master are the ‘slaves’ (see Fig.11).

handbook, full pagewidth

SDA

SCL

data line

stable;

data valid

change

of data

allowed

Fig.9 Bit transfer.

MBC621

1999 Aug 05

11

Share Link: