M41T80(2002) 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M41T80
(Rev.:2002)

SERIAL ACCESS RTC WITH ALARMS

STMicroelectronics 

M41T80

OPERATION

The M41T80 clock operates as a slave device on

the serial bus. Access is obtained by implementing

a start condition followed by the correct slave ad-

dress (D0h). The 20 bytes contained in the device

can then be accessed sequentially in the following

order:

1. Tenths/Hundredths of a Second Register

2. Seconds Register

3. Minutes Register

4. Century/Hours Register

5. Day Register

6. Date Register

7. Month Register

8. Year Register

9. Control Register

10. 32kE Bit

11 - 16. Alarm Registers

17 - 19. Reserved

20 - Square Wave Register

2-Wire Bus Characteristics

The bus is intended for communication between

different IC’s. It consists of two lines: a bi-direction-

al data signal (SDA) and a clock signal (SCL).

Both the SDA and SCL lines must be connected to

a positive supply voltage via a pull-up resistor.

The following protocol has been defined:

– Data transfer may be initiated only when the bus

is not busy.

– During data transfer, the data line must remain

stable whenever the clock line is High.

– Changes in the data line, while the clock line is

High, will be interpreted as control signals.

Accordingly, the following bus conditions have

been defined:

Bus not busy. Both data and clock lines remain

High.

Start data transfer. A change in the state of the

data line, from high to Low, while the clock is High,

defines the START condition.

Stop data transfer. A change in the state of the

data line, from Low to High, while the clock is High,

defines the STOP condition.

Data Valid. The state of the data line represents

valid data when after a start condition, the data line

is stable for the duration of the high period of the

clock signal. The data on the line may be changed

during the Low period of the clock signal. There is

one clock pulse per bit of data.

Each data transfer is initiated with a start condition

and terminated with a stop condition. The number

of data bytes transferred between the start and

stop conditions is not limited. The information is

transmitted byte-wide and each receiver acknowl-

edges with a ninth bit.

By definition a device that gives out a message is

called “transmitter,” the receiving device that gets

the message is called “receiver.” The device that

controls the message is called “master.” The de-

vices that are controlled by the master are called

“slaves.”

Acknowledge. Each byte of eight bits is followed

by one Acknowledge Bit. This Acknowledge Bit is

a low level put on the bus by the receiver whereas

the master generates an extra acknowledge relat-

ed clock pulse. A slave receiver which is ad-

dressed is obliged to generate an acknowledge

after the reception of each byte that has been

clocked out of the slave transmitter.

The device that acknowledges has to pull down

the SDA line during the acknowledge clock pulse

in such a way that the SDA line is a stable Low dur-

ing the High period of the acknowledge related

clock pulse. Of course, setup and hold times must

be taken into account. A master receiver must sig-

nal an end of data to the slave transmitter by not

generating an acknowledge on the last byte that

has been clocked out of the slave. In this case the

transmitter must leave the data line High to enable

the master to generate the STOP condition.

7/20

Share Link: