M41T00(2015) 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M41T00
(Rev.:2015)

Serial real-time clock

STMicroelectronics 

M41T00

2

Device operation

Device operation

The M41T00 clock operates as a slave device on the serial bus. Access is obtained by

implementing a start condition followed by the correct slave address (D0h). The 8 bytes

contained in the device can then be accessed sequentially in the following order:

1st byte: seconds register

2nd byte: minutes register

3rd byte: century/hours register

4th byte: day register

5th byte: date register

6th byte: month register

7th byte: years register

8th byte: control register

The M41T00 clock continually monitors VCC for an out of tolerance condition. Should VCC

fall below VSO, the device terminates an access in progress and resets the device address

counter. Inputs to the device will not be recognized at this time to prevent erroneous data

from being written to the device from an out of tolerance system. When VCC falls below VSO,

the device automatically switches over to the battery and powers down into an ultra low

current mode of operation to conserve battery life. Upon power-up, the device switches from

battery to VCC at VSO and recognizes inputs.

2.1

Wire bus characteristics

This bus is intended for communication between different ICs. It consists of two lines: one

bi-directional for data signals (SDA) and one for clock signals (SCL). Both the SDA and the

SCL lines must be connected to a positive supply voltage via a pull-up resistor.

The following protocol has been defined:

 Data transfer may be initiated only when the bus is not busy.

 During data transfer, the data line must remain stable whenever the clock line is High.

Changes in the data line while the clock line is High will be interpreted as control

signals.

Accordingly, the following bus conditions have been defined:

2.2

Bus not busy

Both data and clock lines remain high.

2.3

Start data transfer

A change in the state of the data line, from high to low, while the clock is high, defines the

START condition.

DocID6100 Rev 10

7/25

25

Share Link: