VSC9142 查看數據表（PDF） - Vitesse Semiconductor

零件编号

产品描述 (功能)

生产厂家

VSC9142

STS-48c Packet/ATM Over SONET/SDH Device With Integrated Mux/Demux and Clock and Data Recovery

Vitesse Semiconductor 

VITESSE

SEMICONDUCTOR CORPORATION

STS-48c Packet/ATM Over SONET/SDH Device

With Integrated Mux/Demux and Clock and Data Recovery

Preliminary Datasheet

VSC9142

• Transmitted Aborted HDLC frames

• Transmitted FCS Errored HDLC frames

• Long packets read from Tx FIFO

• Short packets read from Tx FIFO

• Transmitted empty HDLC frames

• Bytes pre octet-stuffing (excluding Abort sequences)

• Bytes post octet-stuffing (excluding Abort sequences)

• The SPE Transparent Mode is provided to allow the Tx FIFO content to be passed directly into the SPE

payload without further processing.

• A timestamp signal TXTS is provided to indicate when the first word of a packet is read from the Tx

FIFO.

Transmit Path Overhead Processor (TPOP)

• The H1 and H2 pointer byte values are programmable to support both SONET and SDH. Several pointer

functions are provided for diagnostics purposes. The remaining 47 H1 and H2 bytes are programmable.

• The Path BIP-8 is computed and placed in the B3 byte of the current frame. It is possible to insert B3

errors for diagnostic purposes.

• The number of Path BIP-8 errors detected in the Receive Path Overhead Processor (RPOP) is backre-

ported as Path REI in the G1 byte. Both individual and block mode backreporting for G1 are supported.

• It is possible to enable/disable RDI-P insertion for each of the following alarms: LOS, LOF, AIS-L, AIS-

P, LOP-P, TIM-P, UNEQ-P, LCD-P and PLM-P. Both the latest and earlier definitions of RDI-P are sup-

ported.

• The Path Signal Label (C2) byte value is programmable.

• The Path Trace (J1) byte value is programmable.

• The F2, H4, Z3, Z4, and Z5 bytes are programmable.

Transmit Line Overhead Processor (TLOP)

• It is possible to insert programmable sets of K1 and K2 bytes into the outgoing data stream.

• RDI-L can be automatically inserted during the detection of an LOS, LOF, or AIS-L alarm in the receive

data stream.

• The Line BIP-384 code is computed and placed in the B2 bytes of the current frame. It is possible to

insert B2 errors for diagnostics purposes.

• The number of Line BIP-384 errors detected in the Receive Line Overhead Processor (RLOP) is backre-

ported as Line REI in the M1 byte. Up to 255 errors can be backreported per frame in individual mode.

Both individual and block mode backreporting for M1 are supported. It is possible to insert M1 error

indications for diagnostics purposes.

• The Synchronization Status value inserted in the S1 byte is programmable.

Page 8

 VITESSE SEMICONDUCTOR CORPORATION

741 Calle Plano, Camarillo, CA 93012 • 805/388-3700 • FAX: 805/987-5896

G52319-0, Rev. 3.1

6/12/00

Share Link: