STPCC03 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

STPCC03

PC Compatible Embeded Microprocessor

STMicroelectronics 

GENERAL DESCRIPTION

1 GENERAL DESCRIPTION

At the heart of the STPC Consumer-S is an ad-

vanced 64-bit processor block, dubbed the

5ST86. The 5ST86 includes a 486 processor core

along with a 64-bit SDRAM controller, advanced

64-bit accelerated graphics and video controller, a

high speed PCI local-bus controller and Industry

standard PC chip set functions (Interrupt control-

ler, DMA Controller, Interval timer and ISA bus).

The STPC Consumer-S makes use of a tightly

coupled Unified Memory Architecture (UMA),

where the same memory array is used for CPU

main memory and graphics frame-buffer. This

means a reduction in total system memory for sys-

tem performances that are equal to that of a com-

parable frame buffer and system memory based

system, and generally much better, due to the

higher memory bandwidth allowed by attaching

the graphics engine directly to the 64-bit proces-

sor host interface running at the speed of the proc-

essor bus rather than the traditional PCI bus.

The 64-bit wide memory array provides the sys-

tem with 528MB/s peak bandwidth. This allows for

higher resolution screens and greater color depth.

The ‘standard’ PC chipset functions (DMA, inter-

rupt controller, timers, power management logic)

are integrated together with the x86 processor

core; additional functions such as communica-

tions ports are accessed by the STPC Consumer-

S via internal ISA bus.

The PCI bus is the main data communication link

to the STPC Consumer-S chip. The STPC Con-

sumer-S translates appropriate host bus I/O and

Memory cycles onto the PCI bus. It also supports

generation of Configuration cycles on the PCI bus.

The STPC Consumer-S, as a PCI bus agent (host

bridge class), fully complies with PCI specification

2.1. The chip-set also implements the PCI manda-

tory header registers in Type 0 PCI configuration

space for easy porting of PCI aware system BI-

OS. The device contains a PCI arbitration function

for three external PCI devices.

The STPC Consumer-S has two functionnal

blocks sharing the same balls : The ISA / IPC /

IDE block and the Local Bus / IDE block (see Ta-

ble 3). Any board with the STPC Consumer-S

should be built using only one of these two config-

urations.

At reset, the configuration is done by ‘strap op-

tions’ which initialises the STPC Consumer-S to

the right settings. It is a set of pull-up or pull-down

resistors on the memory data bus, checked on re-

set, which auto-configure the STPC Consumer-S.

GRAPHICS FUNCTIONS

Graphics functions are controlled through the on-

chip SVGA controller and the monitor display is

produced through the 2D graphics display engine.

This Graphics Engine is tuned to work with the

host CPU to provide a balanced graphics system

with a low silicon area cost. It performs limited

graphics drawing operations which include hard-

ware acceleration of text, bitblts, transparent blts

and fills. The results of these operations change

the contents of the on-screen or off-screen frame

buffer areas of DRAM memory. The frame buffer

can occupy a space up to 4 Mbytes anywhere in

the physical main memory and always starts from

the bottom of the main physical memory.

The graphics resolution supported is a maximum

of 1280x1024 in 65536 colours and 1024x768 in

true color at 75Hz refresh rate and is VGA and

SVGA compatible. Horizontal timing fields are

VGA compatible while the vertical fields are ex-

tended by one bit to accommodate above display

resolution.

VIDEO FUNCTIONS

The STPC Consumer-S provides several addition-

al functions to handle MPEG or similar video

streams. The Video Input Port accepts an encod-

ed digital video stream in one of a number of in-

dustry standard formats, decodes it, optionally

decimates it, and deposits it into an off screen

area of the frame buffer. An interrupt request can

be generated when an entire field or frame has

been captured. The video output pipeline incorpo-

rates a video-scaler and color space converter

function and provisions in the CRT controller to

display a video window. While repainting the

screen the CRT controller fetches both the video

as well as the normal non-video frame buffer in

two separate internal FIFOs. The video stream

can be color-space converted (optionally) and

smooth scaled. Smooth interpolative scaling in

both horizontal and vertical direction are imple-

mented. Color and Chroma key functions are also

implemented to allow mixing video stream with

non-video frame buffer.

The video output passes directly to the RAMDAC

for monitor output or through another optional

color space converter (RGB to 4:2:2 YCrCb) to the

programmable anti-flicker filter. The flicker filter is

configured as either a two line filter with gamma

correction (primarily designed for DOS type text)

or a 3 line flicker filter (primarily designed for Win-

dows type displays). The fliker filter is optional and

can be software disabled for use with large screen

area’s of video.

4/51

Release B

This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice.

Share Link: