SPT9402SCR 查看數據表（PDF） - Signal Processing Technologies
零件编号
产品描述 (功能)
生产厂家
SPT9402SCR Datasheet PDF : 4 Pages
| |||
ABSOLUTE MAXIMUM RATINGS (Beyond which damage may occur)(1) 25 °C
Supply Voltages
VCC ....................................................................... +6.0 V
Maximum Power Dissipation
PD .................................................................................... 350 mW
Thermal Impedance (TA=+25 °C and above)
ΘCA ............................................................................ 2.8 mW/°C
Temperature
Operating Temperature ................................. 0 to +70 °C
Storage Temperature ................................ -55 to +150 °C
Note: 1. Operation at any Absolute Maximum Rating is not implied. See Electrical Specifications for proper nominal
applied conditions in typical applications.
ELECTRICAL SPECIFICATIONS
TA = +25 °C, VCC = +5.0 V, VIN = 1.0 VP-P video signal, voltage gain of +2, RL = 150 Ω, unless otherwise specified.
PARAMETERS
Power Supply
Supply Current (ICC)
VCC Voltage
Power Dissipation
Standby Current
Standby Power Dissipation
Digital Input
Digital Input (Low)
Digital Input (High)
Dynamic Performance
Voltage Gain
Total Harmonic Distortion
Open Loop Gain
Bandwidth
Slew Rate
Frequency Response
Cross Talk
TEST
CONDITIONS
No Input
Pin 2 Grounded
Pin 2 Grounded
Standby Pin 2
Standby Pin 2
fIN = 1 MHz
fIN = 1 kHz
fIN = 1 to 5 MHz
fIN = 1 MHz
TEST
LEVEL
I
IV
I
I
I
I
I
I
I
V
V
V
V
V
SPT9402
MIN
TYP
19
4.5
5.0
95
22.5
113
0.0
0.1
1.8
2.0
5.7
6.0
0.2
40
20
70
-0.9
-40
MAX UNITS
27 mA
5.5 V
135 mW
50 µA
250 µW
0.3 V
VCC V
6.3 dB
1.0 %
dB
MHz
V/µs
dB
dB
TEST LEVEL CODES
All electrical characteristics are subject to the following
conditions:
All parameters having min/max specifications are guar-
anteed. The Test Level column indicates the specific
device testing actually performed during production and
Quality Assurance inspection. Any blank section in the
data column indicates that the specification is not tested
at the specified condition.
TEST LEVEL
I
II
III
IV
V
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at TA = +25 °C, and sample tested
at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design and
characterization data.
Parameter is a typical value for information purposes only.
100% production tested at TA = +25 °C. Parameter is
guaranteed over specified temperature range.
SPT
2
SPT9402
8/24/98
Share Link: 