CA3059 查看數據表（PDF） - Motorola => Freescale
零件编号
产品描述 (功能)
生产厂家
CA3059 Datasheet PDF : 6 Pages
| |||
CF
+
100 µF
15 V
–
2
RS
85 k
AC Line
Input
5
CA3059
Figure 14. Circuit Schematic
RP
Inhibit
Input
1
Rx
NTC Sensor
13
10 k
50 k
10
70 µA
9
9.6 k
11
8
35 µA
15
3 Current
Boost
25
30 k
30 k
30 k
53 µA
150 µA
5k
50 k
4
To
Thyristor
Gate
12
For DC Mode
or 400 Hz
Operation
14
Fail–Safe
Input
7
To
Common
NOTE: Current sources are established by an internal reference.
6
For
External
Trigger
APPLICATION INFORMATION
Power Supply
The CA3059 is a self–powered circuit, powered from the
AC line through an appropriate dropping resistor (see Table
A). The internal supply is designed to power the auxiliary
power circuits.
In applications where more output current from the internal
supply is required, an external power supply of higher voltage
should be used. To use an external power supply, connect
Pin 5 and Pin 7 together and apply the synchronizing voltage
to Pin 12 and the DC supply voltage to Pin 2 as shown in
Figure 4.
Operation of Protection Circuit
The protection circuit, when connected, will remove
current drive from the triac if an open or shorted sensor is
detected. This circuit is activated by connecting Pin 13 to
Pin 14 (see Figure 1).
The following conditions should be observed when the
protection circuit is utilized:
a. The internal supply should be used and the external
load current must be limited to 2 mA with a 5 kΩ
dropping resistor.
b. Sensor Resistance (RX) and RP values should be
between 2 kΩ and 100 kΩ.
c. The relationship 0.33 < RX/RP < 3 must be met over
the anticipated temperature range to prevent
undesired activation of the circuit. A shunt or series
resistor may have to be added.
External Inhibit Function
A priority inhibit command applied to Pin 1 will remove
current drive from the thyristor. A command of at least +1.2 V
@ 10 µA is required. A DTL or TTL logic 1 applied to Pin 1 will
activate the inhibit function.
DC Gate Current Mode
When comparator operation is desired or inductive loads
are being switched, Pins 7 and 12 should be connected. This
connection disables the zero–crossing detector to permit the
flow of gate current from the differential sensing amplifier on
demand. Care should be exercised to avoid possible
overloading of the internal power supply when operating the
device in this mode. A resistor should be inserted between
Pin 4 and the thyristor gate in order to limit the current.
MOTOROLA ANALOG IC DEVICE DATA
5
Share Link: 