ADM1068ASTZ 查看數據表（PDF） - Analog Devices
零件编号
产品描述 (功能)
生产厂家
ADM1068ASTZ Datasheet PDF : 25 Pages
| |||
Data Sheet
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
32
VX1 1
VX2
VX3
VX4
VP1
VP2
VP3
VH
8
9
PIN 1
INDICATOR
ADM1068
TOP VIEW
(Not to Scale)
25
24 PDO1
PDO2
PDO3
PDO4
PDO5
PDO6
PDO7
PDO8
17
16
ADM1068
NC = NO CONNECT. DO NOT CONNECT TO THIS PIN.
Figure 3. Pin Configuration
Table 4. Pin Function Descriptions
Pin No.
Mnemonic Description
1 to 4
VX1 to VX4 High Impedance Inputs to Supply Fault Detectors. Fault thresholds can be set from 0.573 V to 1.375 V.
(VXx)
Alternatively, these pins can be used as general-purpose digital inputs.
5 to 7
VP1 to VP3 Low Voltage Inputs to Supply Fault Detectors. Three input ranges can be set by altering the input attenuation
(VPx)
on a potential divider connected to these pins, the output of which connects to a supply fault detector. These
pins allow thresholds from 2.5 V to 6.0 V, from 1.25 V to 3.00 V, and from 0.573 V to 1.375 V.
8
VH
High Voltage Input to Supply Fault Detectors. Three input ranges can be set by altering the input attenuation
on a potential divider connected to this pin, the output of which connects to a supply fault detector. This pin
allows thresholds from 6.0 V to 14.4 V and from 2.5 V to 6.0 V.
9
AGND1
Ground Return for Input Attenuators.
10
REFGND1 Ground Return for On-Chip Reference Circuits.
11
NC
No Connect. Do not connect to this pin.
12
REFOUT Reference Output, 2.048 V. Note that the capacitor must be connected between this pin and REFGND. A 10 μF
capacitor is recommended for this purpose.
13 to 16
NC
No Connect. Do not connect to these pins.
17 to 24
PDO8 to
PDO1
Programmable Output Drivers.
25
PDOGND1 Ground Return for Output Drivers.
26
VCCP
Central Charge-Pump Voltage of 5.25 V. A reservoir capacitor must be connected between this pin and GND.
A 10 μF capacitor is recommended for this purpose.
27
A0
Logic Input. This pin sets the seventh bit of the SMBus interface address.
28
A1
Logic Input. This pin sets the sixth bit of the SMBus interface address.
29
SCL
SMBus Clock Pin. Bidirectional open drain requires external resistive pull-up.
30
SDA
SMBus Data Pin. Bidirectional open drain requires external resistive pull-up.
31
VDDCAP Device Supply Voltage. Linearly regulated from the highest of the VPx, VH pins to a typical of 4.75 V. Note that the
capacitor must be connected between this pin and GND. A 10 μF capacitor is recommended for this purpose.
32
GND1
Supply Ground.
1 In a typical application, all ground pins are connected together.
Rev. D | Page 7 of 25
Share Link: 