TC850CPL 查看數據表（PDF） - TelCom Semiconductor Inc => Microchip

零件编号

产品描述 (功能)

生产厂家

TC850CPL

15-BIT, FAST-INTEGRATING CMOS ANALOG-TO-DIGITAL CONVERTER

TelCom Semiconductor Inc => Microchip 

15-BIT, FAST-INTEGRATING CMOS

ANALOG-TO-DIGITAL CONVERTER

1

TC850

INTERNAL

.......

1280 CLOCK CYCLES

..

............

2

CLOCK

246

256

778

CONVERSION

PHASE

ZERO INTEGRATOR

SIGNAL

INTEGRATE

REFERENCE INTEGRATE

Figure 4. Conversion Timing

3

Zero-Integrator Phase

During the zero-integrator phase, the differential input

signal is disconnected from the circuit by opening internal

analog gates. The internal nodes are shorted to analog

common (ground) to establish a zero-input condition. At the

same time, a feedback loop is closed around the input buffer,

integrator, and comparator. The feedback loop ensures the

integrator output is near 0V before the signal-integrate

phase begins.

During this phase, a chopper-stabilization technique is

used to cancel offset errors in the input buffer, integrator,

and comparator. Error voltages are stored on the CBUFF,

CINT, and COMP capacitors. The zero-integrate phase

requires 246 clock cycles.

Signal-Integrate Phase

The zero-integrator loop is opened and the internal

differential inputs are connected to IN+ and IN–. The differ-

ential input signal is integrated for a fixed time period. The

TC850 signal-integrate period is 256 clock periods, or counts.

The crystal oscillator frequency is Ϭ4 before clocking the

internal counters.

The integration time period is:

tSI =

4

fOSC

× 256

Reference-Integrate Phase

During reference-integrate phase, the charge stored on

the integrator capacitor is discharged. The time required to

discharge the capacitor is proportional to the analog input

voltage.

The reference integrate phase is divided into three

subphases: (1) fast, (2) slow, and (3) overrange deintegrate.

During fast deintegrate, VIN– is internally connected to

analog common and VIN+ is connected across the previously-

charged reference capacitor (CREF1). The integrator capaci-

tor is rapidly discharged for a maximum of 512 internal clock

pulses, yielding 9 bits of resolution.

During the slow deintegrate phase, the internal VIN+

node is now connected to the CREF2 capacitor, and the

residual charge on the integrator capacitor is further dis-

4 charged a maximum of 64 clock pulses. At this point, the

analog input voltage has been converted with 15 bits of

resolution.

If the analog input is greater than full scale, the TC850

performs up to three overrange deintegrate subphases.

Each subphase occupies a maximum of 64 clock pulses.

The overrange feature permits analog inputs up to 192 LSBs

greater than full scale to be correctly converted. This feature

5 permits the user to digitally null up to 192 counts of input

offset, while retaining full 15-bit resolution.

In addition to 512 counts of fast, 64 counts of slow, and

192 counts of overrange deintegrate, the reference-inte-

grate phase uses 10 clock pulses to permit internal nodes to

settle. Therefore, the reference integrate cycle occupies 778

clock pulses.

Pin Description (Analog)

Differential Inputs (IN+ and IN–)

6

The analog signal to be measured is applied at the IN+

and IN– inputs. The differential input voltage must be within

the common-mode range of the converter. The input com-

mon-mode range extends from VDD –1.5V to VSS +1.5V.

Within this common-mode voltage range, an 86 dB CMRR

is typical.

7 The integrator output also follows the common-mode

voltage. The integrator output must not be allowed to satu-

rate. A worst-case condition exists, for example, when a

large, positive common-mode voltage with a near full-scale

negative differential input voltage is applied. The negative

input signal drives the integrator positive when most of its

available swing has been used up by the positive common-

mode voltage. For applications where maximum common-

8 mode range is critical, integrator swing can be reduced. The

integrator output can swing within 0.4V of either supply

without loss of linearity.

TELCOM SEMICONDUCTOR, INC.

3-83

Share Link: