®
C42
MKP62 Series
2 Test Method And Performance
No.
Item
Performance
Test Method (IEC 60384-14)
1
Solderability
Good quality of tinning
There shall be no visible damage
2
Terminal strength
Solder temperature: 245˚C ±5˚C
Immersion time: 2.0s±0.5s
Tense: 0.50<d≤0.80, 10N
0.80<d≤1.25, 20N
Bend: 0.50<d≤0.80, 5N
0.80<d≤1.25, 10N
The terminals shall be bent 2 times in
each direction
3
Resistance to solder heat
There shall be no visible damage
ΔC/C ≤±5%(relative to the initial value)
Solder temperature:260˚C±5˚C
Immersion time: 10s±1s
The marking shall be legible
Solvent: Industrial isopropanol.
Solvent temperature:23˚C±5˚C
4
Solvent resistance of the
marking
Dipping time: 5min±0.5min
Condition:scrub
Scrub material:absorbent cotton
Reverting time:No
Initial measurement
Capacitance、Tgδ
Rapid change of
temperature
There shall be no evidence of θA=-40˚C, θB =+110˚C
deterioration.
Duration: t=30min
5 cycles
There shall be no evidence of Amplitude 0.75mm or acceleration
deterioration.
100m/s2 (whichever is the smaller
Vibration
5
severity), f: 10Hz to 500Hz.Three
directions, 2h foreach direction, total
6h.
Bump
There shall be no evidence of 4 000 times,
deterioration.
Acceleration: 400m/s2,
Pulse duration, 6ms
Final measurement
There shall be no visible damage
ΔC/C ≤±5%(relative to the initial value)
Initial
measurement
Dry heat
+110℃, 16h
Damp
heat,Cyclic
Test Db, Severity: b, the first cycle
Cold
-40℃, 2h
Damp heat,
cyclic other
climate
6 sequence
Test Db, Severity b, the other cycles,
Final
measurement
There shall be no visible damage,
legible marking
ΔC/C ≤±5%(relative to the initial
value)
Increase of tgδ:
CR≤1μF: ≤0.008 (10kHz)
CR>1μF: ≤0.005 (1kHz)
Dielectric strength : there shall be no
permanent breakdown or flashover
I.R.: ≥ 50% of the rated value
Page 8 of 12