67954-002LF 查看數據表（PDF） - First Components International

零件编号

产品描述 (功能)

生产厂家

67954-002LF

Basics+,Mini-PV™ : 2.54 x 2.54 mm (0.1 x 0.1 in.) Centerline Crimp-to-Wire PV Receptacle Housing, Double Row

First Components International 

TYPE

PRODUCT SPECIFICATION

NUMBER

BUS-12-067

TITLE

Crimp-to Wire, Mini-PV™ Receptacles and Mini-Latch Housings

PAGE

REVISION

10 of 16

K

AUTHORIZED BY

DATE

H.T. Brewbaker 31-May-06

CLASSIFICATION

UNRESTRICTED

TABLE II - MATING FORCES

Spring Thickness (Mils)

Force (Grams)

3.5

150

4.8

300

5.8

525

6.5

725

7.4 Individual Contact Insertion Force - When measured using a maximum guage pin configured as shown

in Figure 5, the typical individual contact insertion force shall not be greater than the value shown in

Table III.

7.5 Individual Contact Withdrawal Force - After five insertions using a maximum guage pin configured as

shown in Figure 5, the typical individual contact withdrawal force shall not be less than the value shown

in Table III when measured using a minimum guage pin configured as shown in Figure 5.

TABLE III - CONTACT FORCES

Contact Force (Grams)

Spring Thickness (Mils) Insertion (Max) Withdrawal (Min)

3.5

240

45

4.8

450

75

5.8

700

130

6.5

1100

175

7.6 Durability - After 1000 mating/unmating cycles with 0.025 inch square pin standard Bergstik (R)

Headers, , the 15 u" gold contact (or heavier gold plating) terminals shall be again mated and then

subjected to a moist Hydrogen Sulfide atmosphere (approximately 3 ppm). After 48 hours of H2S per

BUS-03-302, the change in contact resistance shall not exceed 2 milliohms for any spring thickness.

7.7 Tensile Strength, Crimp - The force required to pull the properly crimped wire (per TA-75) from the

terminal shall not be less than the value specified in Table IV when tested in accordance with MIL-

STD-1344, Method 2003, at a cross-head parting speed of one inch per minute maximum.

TABLE IV - CRIMP TENSILE STRENGTH

Wire Size, AWG Strength, Lbs Wire Size, AWG Strength, Lbs

18

32.0

28

5.0

20

28.0

30

2.5

22

16.0

32

1.5

24

11.0

34

1.0

26

6.5

36

0.5

Copyright FCI

Form E-3334

Rev E

PDM: Rev:K

GS-01-001

STATUS:Released Printed: Nov 28, 2010.

Share Link: