KL5KUSB110 查看數據表（PDF） - KAWASAKI MICROELECTRONICS

零件编号

产品描述 (功能)

生产厂家

KL5KUSB110

USB to ATAPI

KAWASAKI MICROELECTRONICS 

K KAWASAKI

LSI

Preliminary

USB to ATAPI

IDE Port

8 or 16 bits, data port, supports Master/Slave multiple disks . Either ATAPI or IDE commands,

Supports ATA-1 ,2 &3 standards. Max Disk operation throughput rate is up to 1 Mbytes/sec

WDM ATAPI/IDE Drivers

Development Kit includes generic PnP USB mini-port driver, ATAPI Driver for Windows 98

/NT2000 and Mac8.5 for IDE Disk Drive class devices . Development time is significantly

reduced.

PLL Clock Generator

The PLL circuitry is provided to generate the internal 48MHz clock requirements. This circuitry is

designed to allow use of a low cost 12 MHz external crystal which is connected to the USB3 pins

X1 and X2. If an external 12 MHz clock is available in the application, it may be used in lieu of

the crystal circuit and connected directly to the X1 input pin.

USB Interface

The USB controller meets the Universal Serial Bus (USB) specification ver 1.0 and 1.1. The

transceiver is capable of transmitting and receiving serial data at the USB’s full speed, 12

Mbits/sec data rate. The driver portion of the transceiver is differential, while the receive section

is comprised of a differential receiver and two single ended receivers. Internally, the transceiver

interfaces to the SIE logic. Externally, the transceiver connects to the physical layer of the USB.

UART Serial Interface

The UART can be configured for a wide selection of baud rates, 300 to 230.4 K baud, and

support a set of control signals. Each UART provides a means for external serial devices to

access the USB.

Serial EEPROM Support

The USB Controller serial interface is used to provide access to external EEPROM’s. The

interface can support a variety of serial EEPROM formats.

Development Kit

• For all of its products, Kawasaki offers Development Kits (DVKs), USB to IDE reference

design board, training, and integration assistance from an experienced staff of engineers . By

using the DVKs, Kawasaki customers can have a working USB product within 3 weeks.

The following items are included in the KL5KUSB110Development Kit:

• WDM Windows 98/NT2000 and Mac8.5 drivers, and ATAPI to USB driver object code,

optional source code

• USB to ATAPI/IDE protocol translator firmware source code example

• PnP USB ATAPI Disk Drive Demo object code, optional source code examples is available

• Application notes

Kawasaki LSI • 2570 North First Street • Suite 301 • San Jose, CA 95131 • Tel: (408) 570-0555 • Fax: (408) 570-0567 • www.klsi.com

Ver. 1..0

3

Share Link: