DS1990 查看數據表（PDF） - Dallas Semiconductor -> Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

DS1990

Serial Number iButton™

Dallas Semiconductor -> Maxim Integrated 

NOTES:

1. All voltages are referenced to ground.

DS1990A

2. VPUP = external pullup voltage.

3. Input load is to ground.

4. An additional reset or communication sequence cannot begin until the reset high time has expired.

5. Read data setup time refers to the time the host must pull the 1-Wire bus low to read a bit. Data is

guaranteed to be valid within 1 µs of this falling edge and will remain valid for 14 µs minimum. (15

µs total from falling edge on 1-Wire bus.)

6. VIH is a function of the external pullup resistor and the VCC supply.

7. 30 nanocoulombs per 72 time slots @ 5.0V.

8. At VCC =5.0V with a 5 kΩ pullup to V CC and a maximum time slot of 120 µs.

9. Capacitance on the I/O pin could be 800 pF when power is first applied. If a 5 kΩ resistor is used to

pull up the I/O line to VCC , 5 µs after power has been applied the parasite capacitance will not affect

normal communications.

10. The reset low time (tRSTL ) should be restricted to a maximum of 960 µs, to allow interrupt signaling,

otherwise, it could mask or conceal interrupt pulses if this device is used in parallel with a DS1994.

10 of 10

Share Link: